Sanyo HT27547 用户手册
5
Press the POWER key. (Follow on-screen instructions).
14
6
Perform “All Channel Search.” The All
Channel Search will search for off-air digital
and analog channels, and analog cable
channels. The DTV can receive cable or off-
air channels, but not at the same time. If
after two searches the DTV still fails to
detect any channels, the DTV will tune to
Video1.
Channel Search will search for off-air digital
and analog channels, and analog cable
channels. The DTV can receive cable or off-
air channels, but not at the same time. If
after two searches the DTV still fails to
detect any channels, the DTV will tune to
Video1.
4
Plug AC Power Cord (supplied) into an
electrical outlet as shown here.
electrical outlet as shown here.
To 120 V AC outlet.
GETTING STARTED (REQUIRED INITIAL SETUP)
Continued
Channel Search [Analog & Digital]
on-screen display
on-screen display
3
Connect Signal to the DTV’s an Analog 75 ohm Antenna Input terminal.
THE TUNER IN THIS DTV CAN RECEIVE:
1. Digital and / or Analog Off-Air Signals from an RF
antenna.
OR
2. Analog or ClearQAM cable channels.
Note:You must search for ClearQAM channels
using the “Digital Cable Search” menu
option.
option.
OR
3. The output from a VCR or cable box.
Digital signals from a Set-Top (STB) Box should be
received through the Component jacks.
received through the Component jacks.
This DTV can receive ANY unscrambled RF signal
being broadcast.
being broadcast.
Analog RF Antenna Connection
Connect a Cable signal (with or without a cable
box) or RF antenna to the Analog RF input.
box) or RF antenna to the Analog RF input.
ANALOG CABLE
RF
ANTENNA
DTV BACK
OR
OR
POWER
CABLE BOX OR
SATELLITE BOX