Security Centres TS2000 用户手册

OVERVIEW

Introduction

The Intruder Alarm Control System TS2000 is provided for

large domestic and general commercial intruder

systems conforming to BS 4737 part 1 1986. It is an

extremely versatile system with the following facilities:

Will monitor up to 128 zones using various types of

detector device;

Will provide up to 136 output signals whose

response may be programmed;

May be programmed to provide a large number

of operational options and facilities.

As the system is microprocessor controlled it must be

programmed initially to select the required user options

such as number of zones, type of alarm and time of

operation. The general principle of operation is to

monitor protected zones, each having a detection

circuit, to detect the circuit status, then to respond

accordingly. As each zone has a circuit the terms Zone

and Circuit may be considered as being synonymous

but the term Circuit is generally used. Circuits may also

be grouped into wards.

Equipment

The system consists of a number of units that are

interconnected by a Control Network:

Control Panel (CP): This is the controlling panel for the

system which:

(a)

provides power to the system;

(b)

communicates with and monitors the state of

the units connected to the Control Network and

responds to alarm conditions according to the

pre-programmed instructions;

(c)

provides special outputs to a printer, a Digital

Communicator, a Modem and other devices if

required.

It has no front panel controls and may be sited at any

convenient internal location.

Node Unit (NU): a unit that is remote from the CP and

is connected to it via the Control Network. It will

monitor the status of up to four circuits and will also

provide up to four programmable outputs which are

controlled by the CP;

Remote Keypad Node Unit (REM): has the same

functions as the NU and in addition has a Keyboard

and a 40 character display to allow operators to

control the system.

The system will consist of a CP connected, via the

Control Network, to up to 32 NU’s and or REM’s so

providing up to 128 circuits and programmable outputs

each of whose functioning and use are

pre-programmed. At least one REM is required to control

the system.

CP Options

Additional boards may be fitted to the CP as follows:

Serial Interface Board (SlB): Provides a serial output:

(a)

RS232 format for a serial printer;

(b)

RS232 format to any suitable equipment;

Parallel Interface Board (PIB): Provides up to eight

output ports which may be programmed to respond

to system activity and which can also be used to

provide outputs to a separate Digital

Communicator. It also has a (telephone) Line Fault

input port.

Digital Communicator type DC3 (Digicom): Will

transfer status information from the CP to a

dedicated Central Station via PSTN lines. When

activated via any of its eight logic input channels it

will:

(a)

Dial one or two telephone numbers;

(b)

Transfer an account (identity) number to the

dialled station;

(c)

Transfer channel status information.

Modem type DC3M (Digimodem): Will transfer data over

PSTN lines to any suitable equipment such as a modem

for a computer terminal. When activated the system will

dial one or two telephone numbers and will be capable

of transferring all commissioning information, event log

data etc., to a remote maintenance centre. The

remote maintenance centre may also call the DC3M

and transfer data to it.

TS2000

2 of 20

496529 Issue A

TS2000