ONKYO A-9377 用户手册
17
Adjusting the Bass, Treble, and Balance
Notes:
• Signals output by the TAPE OUT L/R jacks are not
• Signals output by the TAPE OUT L/R jacks are not
affected by the A-9377’s Volume, BALANCE, BASS,
and TREBLE controls.
and TREBLE controls.
• If you’re using an Onkyo cassette deck that’s con-
nected via
, for dubbing or synchro recording, set
the REC SELECTOR to SOURCE.
Use the BASS control to adjust
the bass.
Turn the control clockwise to increase
the level of bass sounds; counterclock-
wise to decrease the level.
the bass.
Turn the control clockwise to increase
the level of bass sounds; counterclock-
wise to decrease the level.
Use the TREBLE control to adjust
the treble.
Turn the control clockwise to increase
the level of treble sounds; counter-
clockwise to decrease the level.
the treble.
Turn the control clockwise to increase
the level of treble sounds; counter-
clockwise to decrease the level.
Use the BALANCE control to
adjust the left/right balance.
Turn the control clockwise to increase
the level of right speaker; counter-
clockwise to increase the level of left
speaker. Normally, it should be set to
the central position.
adjust the left/right balance.
Turn the control clockwise to increase
the level of right speaker; counter-
clockwise to increase the level of left
speaker. Normally, it should be set to
the central position.
TREBLE
BASS
BALANCE
Recording
1
Use the REC SELECTOR to
select the source you want to
record.
LINE: Component connected to the
LINE jacks.
PHONO: Turntable connected to the
PHONO jacks.
CD: Component connected to the CD
jacks.
OFF: Nothing is output by the TAPE
OUT L/R jacks.
TUNER: Component connected to the
TUNER jacks.
DOCK: Component connected to the
DOCK jacks.
SOURCE: Component selected by the
Input Selector.
select the source you want to
record.
LINE: Component connected to the
LINE jacks.
PHONO: Turntable connected to the
PHONO jacks.
CD: Component connected to the CD
jacks.
OFF: Nothing is output by the TAPE
OUT L/R jacks.
TUNER: Component connected to the
TUNER jacks.
DOCK: Component connected to the
DOCK jacks.
SOURCE: Component selected by the
Input Selector.
2
Prepare the recorder:
• Set the recorder so that it’s ready for
• Set the recorder so that it’s ready for
recording.
• If necessary, adjust the recording
level on the recorder.
• See the recorder’s instruction manual
for more information.
3
Start playback on the source
component.
component.
Unless you have the full consent of the
copyright holder, copyright laws prohibit
using your recordings for anything other
than personal enjoyment!
copyright holder, copyright laws prohibit
using your recordings for anything other
than personal enjoyment!
REC SELECTOR