National Instruments PXI PXI-1006 用户手册
© National Instruments Corporation
3-1
3
Troubleshooting
This chapter describes basic troubleshooting procedures you can perform
on the PXI-1006 chassis.
on the PXI-1006 chassis.
Troubleshooting the PXI-1006
Refer to Table 3-1 to troubleshoot the PXI-1006 chassis. The table lists
possible causes for power failure and recommends ways to correct the
problem.
possible causes for power failure and recommends ways to correct the
problem.
Resetting the AC Mains Circuit Breaker
If your PXI-1006 is connected to an AC source and encounters an
over-current condition, the circuit breaker located on the rear panel will trip
to prevent damage to the chassis. Complete the following steps to reset the
circuit breaker:
over-current condition, the circuit breaker located on the rear panel will trip
to prevent damage to the chassis. Complete the following steps to reset the
circuit breaker:
1.
Turn the power switch to the Standby position.
2.
Disconnect the AC line cord.
Table 3-1. Troubleshooting
Possible Cause
What to Do
PXI-1006 chassis is not connected to
power source.
power source.
Make sure that the PXI-1006 is connected to a live
electrical outlet. Try operating another piece of
equipment from this outlet.
electrical outlet. Try operating another piece of
equipment from this outlet.
Power switch is not switched on.
Set the power switch to the On position.
Remote inhibiting input on the rear
panel of the chassis is active.
panel of the chassis is active.
Deactivate your system’s remote inhibiting control.
Circuit breaker is tripped.
Reset the circuit breaker. Refer to the Resetting the AC
Mains Circuit Breaker section in this chapter.
Mains Circuit Breaker section in this chapter.
Power supply has failed.
Contact National Instruments.