Napoleon Grills BIPRO 600 用户手册

www.napoleongrills.com

separate line must be branched off to the side burner unit and enter the side burner opening at the specified 

location.  If the enclosure is to house a propane cylinder, the tank portion of the enclosure must be ventilated 

according to local codes, and must not have communication with the cavity used to enclose the gas grill.  A 

propane cylinder can not be stored below the gas grill.  
BUILT IN CYLINDER ENCLOSURES: Built in cylinder enclosures which completely enclose the cylinder must 

have both of the following:

1. At least one unobstructed ventilation opening on the exposed exterior side of the enclosure located within 

5 in (127 mm) of the top of the enclosure. The opening must have a total free area of more than 20 in

2

 (130 cm

2

) 

for a 20 lb (9.1 kg) cylinder and 30 in

2

 (195 cm

2

) for a 30 lb (13.6 kg) cylinder.

2. At least one ventilation opening on the exposed, exterior side of the enclosure located 1 in (25.4 mm) or 

less from the floor level.  The opening must have a total free area of more than 10 in

2

 (65 cm

2

) for a 20 lb 

(9.1 kg) cylinder and 15 in

2

 (100 cm

2

) for a 30 lb (13.6 kg) cylinder.  The upper edge must be no more than 5 

in (127 mm) above the floor level.

•  The cylinder valve(s) must be readily accessible for hand operation. A door on the enclosure to gain 

access to the cylinder valves is acceptable, provided it is non-locking and can be opened without the 

use of tools.

•  The enclosure for the LP-gas cylinder must isolate the cylinder from the burner compartment to provide 

shielding from radiation, a flame barrier, and protection from foreign material, such as hot drippings.  

The enclosure cannot be located directly below the grill.

•  There must be a minimum clearance of 2 in (51 mm) between the floor of the LP-gas cylinder enclosure 

and the ground.

•  The enclosure must be designed so that the LP-gas cylinder can be connected, disconnected and the 

connections inspected and tested outside the cylinder enclosure.  Any connections that can be disturbed 

when installing the cylinder in the enclosure must be accessible for testing inside the enclosure.

20 lb (9.1 kg)

20 in

2

 (130 cm

2

)

10 in

2

 (65 cm

2

)

30 lb (13.6 kg)

30 in

2

 (195 cm

2

)

15 in

2

 

(100 cm

2

)