Cub Cadet HP LS 27 CC 用户手册

One Log Splitter

• 

One Tongue Assembly

• 

One Operator’s Manual

• 

One Engine Operator’s Manual

• 

Use extreme caution unpacking this 

machine. Some components are very heavy and will 

require additional people or mechanical handling 

equipment.

NOTE: All references in this manual to the left or right side and 

front or back of the log splitter are from the operating position 

only. Exceptions, if any, will be specified. 

TOOLS NEEDED: Safety glasses, leather gloves, wire cutters, pry bar 

and/or claw hammer.

Use a pry bar or claw hammer to loosen and remove the 

1. 

top of the crate.
Use a pry bar or claw hammer to remove the sides of the crate, 

2. 

beginning with the short sides (or left and right side of the log 

splitter). Set the sides of the crate aside to avoid injury.
On the front side of the crate the tongue assembly is 

3. 

attached on the inside of the crate with a cable tie. Cut the 

cable tie to remove the tongue.
Remove the large plastic cover and discard.

4. 

Do NOT remove any wood or cut any 

straps securing the log splitter or its components to 

the log splitter or the crate at this time. Only remove 

straps and/or wood when instructed to do so.

Inspect the bottom of the crate for any protruding staples 

5. 

or wood splinters and remove.
Remove any loose parts included with the log splitter (i.e. 

6. 

operator’s manual, etc.).

Remove the spring clip and clevis pin from the jack stand 

7. 

on the tongue and then pivot the jack stand towards the 

ground into the operating position. See Fig. 3-1.

Secure the jack stand in position with the clevis pin and 

8. 

spring clip. See Fig. 3-1.
With the log splitter still secured to the bottom of the crate, 

9. 

remove two hex bolts and hex nuts from the tank bracket and 

remove the piece of wood inside the tank brackets. See Fig. 3-2.