Clarity ALERTMASTER AL10 用户手册

下载
页码 45
E
N
G
L
I
S
H
Important Safety Instructions
When using your Clarity AL10, basic safety precautions should always be 
followed to reduce the risk of fire, electric shock and persons including 
the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Do not use this product near a bathtub, wash basin, kitchen sink or 
laundry tub, in a wet basement, near a swimming pool or anywhere else 
there is water.160
4. Avoid using a telephone (other than a cordless type) during a storm. 
There may be a remote risk of electrical shock from lightning.
5. Do not use a telephone to report a gas leak in the vicinity of the leak.
6. Unplug this product from the wall outlets before cleaning. Do not use 
liquid cleaners or aerosol cleaners on the product. Use a damp cloth for 
cleaning.
7. Place this product on a stable surface. Serious damage and/or injury 
may result if the product falls.
8. Do not cover the slots and openings on this product. This product 
should never be placed near or over a radiator or heat register. This 
product should not be placed in a built-in installation unless proper 
ventilation is provided.
9. Operate this product using the electrical voltage as stated on the base 
unit or the owner’s manual. If you are not sure of the voltage in your 
home, consult your dealer or local power company.
10. Do not place anything on the power cord. Install the product where 
no one will step or trip on the cord.
11. Do not overload wall outlets or extension cords as this can increase 
the risk of fire or electrical shock.
12. Never push any objects through the slots in the product. They can 
touch dangerous voltage points or short out parts that could result in 
a risk of fire or electrical shock. Never spill liquid of any kind on the 
product.
13. To reduce the risk of electrical shock, do not take this product apart. 
Opening or removing covers may expose you to dangerous voltages or 
other risks. Incorrect reassembly can cause electric shock when the
Important Safety Instructions
appliance is subsequently used.
14. Unplug this product from the wall outlets and refer servicing to the 
manufacturer under the following conditions:
   A. When the power supply cord or plug is frayed or damaged.
   B. If liquid has been spilled into the product.
   C. If the product has been exposed to rain or water.
   D. If the product does not operate normally by following the operating       
       instructions. Adjust only those controls that are covered by the    
       operating instructions. Improper adjustment may require extensive 
       work by a qualified technician to restore the telephone to normal 
       operation.
   E. If the product has been dropped or the case has been damaged.
   F. If the product exhibits a distinct change in performance.
15. Never install telephone wiring during a lightning storm.
16. Never install telephone jacks in wet locations unless the jack is 
specifically designed for wet locations.
17. Never touch uninsulated telephone wires or terminals unless the 
telephone line has been disconnected at the network interface. 
18. Use caution when installing or modifying telephone lines.
19. Use only the power cord and batteries indicated in this manual. Do 
not dispose of batteries in a fire. They may explode. Check with local 
codes for possible special disposal instructions.
20. The apparatus shall not be exposed to dripping or splashing and 
that no objects filled with liquids, such as vases, shall be placed on the 
apparatus.
21. The battery shall not be exposed to excessive heat, such as sunshine, 
fire or the like.
22. The MAINS plug is used as the disconnect device, which shall remain 
readily operable.
1
     2