Motorola Car Satellite TV System DCH3200 用户手册
3 INSTALLATION
17
Operational Check for the Remote Control
The operational check tests communication with the remote control:
Table 3-1 Operational check procedures
Feature Testing
Procedure
Power on
Press POWER on the remote control to turn on the DCH3200.
Tune to the output channel (3 or 4) if using the RF output.
Channel selection
Scan through the channels using the CHANNEL + or - keys.
Tune to several channels by entering the channel number using the
numeric keys.
numeric keys.
Volume control
Press VOLUME + or - on the remote control to increase the volume to
its upper limit, lowest level, and to a comfortable level.
its upper limit, lowest level, and to a comfortable level.
Press MUTE to turn the sound off. Press MUTE again to restore the
sound.
sound.
If the DCH3200 does not operate properly, refer to the
section.
Optimizing the High-Definition Settings
This subsection describes how to optimize SD and HD video settings and closed
captioning based on subscriber preferences.
captioning based on subscriber preferences.
Before you optimize the output settings:
• Connect the DCH3200 receiver to other home entertainment devices
• Plug the DCH3200 receiver into a power outlet
• Initialize the DCH3200 receiver and authorize services
• Turn the TV on
• Plug the DCH3200 receiver into a power outlet
• Initialize the DCH3200 receiver and authorize services
• Turn the TV on
For an HDMI connection, be sure the TV is on and connected to the HDMI connector
before adjusting the settings. Motorola recommends using HDMI cables less than 20
meters long.
before adjusting the settings. Motorola recommends using HDMI cables less than 20
meters long.
To optimize the output settings:
1.
Power off the DCH3200 and then immediately press the
MENU
key on the front
panel. If the TV is on, the on-screen menu lists the settings you can configure: