Albrecht AE 500 用户手册

下载
页码 18
l Never disassemble the receiver.  Never touch the receiver’s core.
l It is adjusted for optimum performance.
l Avoid hot places and locations exposed to direct sunlight.
l Avoid extremely cold places.
l Avoid exposing the receiver to excessive vibrations and dusty places.
l Applicable batteries are either AA-size manganese or alkaline batteries.   Never use any other batteries.
l This receiver require 2.2 to 3.5 volts DC.
l This receiver is capable of receiving AM, FM Narrow Band (Amateur Radio bands, etc.) and FM Wide Band
(general radio broadcasts, etc.) broadcasts at frequencies from 500 kHz to 1300 MHz  .
l This receiver has two Modes, Preset Mode and Expanded Mode.  When purchased the receiver is set in the
Expanded Mode.
l In Expanded Mode, frequencies can be programmed directly using the numeric keys.  Search and Scan can
also be used to find the frequency quickly. Up to 399 different frequencies can be programmed in channel
Memory in this Mode. In addition, a channel Memory swap function is included to rationalize the use of channel
Memory.
Attaching the Antenna
l Hold the antenna base, set it on the receiver’s antenna terminal and turn clockwise to tighten.
(Insert Illustration 1 and 2)
 CAUTIONS
l Always be aware of antenna location to avoid personal injury.
l The following actions may damage the receiver.
 
Do not hold the top of the antenna and attempt to install it . Also do not turn the antenna excessively
when tightening.    (Illust. 3-1)
 
Do not hold the receiver by the antenna when carrying.  (Illust. 3-2)
Installing Batteries
 
Slide the battery cover off to open.    (Illst. 4)
 
Insert two batteries, making sure they are inserted with correct polarity as specified.  (Illst. 5)
 
Slide the battery cover back into position to close.
WARNING
Do not place consumed batteries in a fire. They could explode, causing fire or burns.
CAUTIONS
l Turn the power off when replacing batteries.
l Be sure to insert batteries with correct polarity as specified.
l Mixing new batteries with old batteries shortens the life of the new batteries.
BASIC OPERATIONS
Turning the Power On
 
Press POWER key on the front of the receiver for 1 second or longer.
 
(A power up sound emits and the display comes on.)        (Illust. 6-1, Illust. 6-2)
 
To turn off, press POWER key on the front of the receiver for 1 second or longer.
CAUTIONS
l When not in use, keep it in a place that is out of the reach of infants and small children.
l During extended trips or other times when this receiver is not in use for long period of time, it is recommended
to take the batteries out of the unit. Also keep the batteries stored in a place that is out of the reach of children.
If the batteries are weak, it may happen that the Scanner display shows
bAtt
and the power is turned on and off alternately. In this case it may not be possible to switch off the scanner