Desa Motion Sensor Light Control 5412 用户手册

© 2006 DESA Specialty Products™ 

598-1273-00

•  The Light Control requires 120-volts AC.
•  If you want to use Manual Mode, the control must be 

wired through a switch.

•  Some codes require installation by a qualifi ed 

•  This product is intended for use with the enclosed 

gasket and with a junction box marked for use in wet 
locations.

Model 5412

Light Control

2 Wire

Connectors

6 Screws

(3 sizes included)

Gasket

2 Shells

•  Turns on lighting when motion is detected.
•  Automatically turns lighting off. 
• Photocell keeps the lighting off during daylight 

hours.

•  LED indicates motion was sensed (day or night).

Mounting Bolt

Mounting Strap

Plastic 

Hanger

Rubber Plug

* resets to Auto Mode at dawn.

Note:   When fi rst turned on wait about 1 

1

/

2

 minutes for 

the circuitry to calibrate.

ON-TIME

10 5 1 TEST

10 5 1 TEST

ON-TIME

... back on.

1 Second OFF 

Put the ON-TIME switch in the 1, 5, 
or 10 minute position.

Put the ON-TIME switch on the bottom 
of the sensor in the TEST position.

Manual mode only works at night 
because daylight returns the sensor 
to AUTO.

Flip the light switch off for one second 
then back on to toggle between AUTO 
and MANUAL MODE.

Manual mode works only with the 
ON-TIME switch in the 1, 5, or 10 
position.

MANUAL MODE

AUTO

TEST

*  If you get confused while switching modes, turn the 

power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.

This package includes:

Mode:

On-Time

Works:

Day

Night

5 Seconds

x

x

1, 5, or 10 Minutes

x

To Dawn*

x

2 Flood Lamps 

(some versions)