Bosch HGS7052UC 快速安装指南

 

English • 4

The gas connection is located below the back panel of

the range (See Figure 4, Page 3). It is accessible

through the warming drawer access panel or from the

back of the range. To reach access panel, remove

warming drawer.

Shut off main gas supply valve before disconnecting

the old range and leave it off until the new hook-up

has been completed.  Don’t forget to relight the

The range can be installed using rigid pipe or a CSA

International-certified flexible metal appliance

connector. If using a flexible connector, always use a

new connector.

Apply pipe joint compound orTeflon* tape appropriate

for use with LP gas and Natural gas around all male

pipe threads to prevent leaks.

If not already present, install gas shut off valve in an

easily accessible location. Make sure all users know

where and how to shut off the gas supply to the

range.

Flexible Connector Method (see Figure 5,

 

this page)

1. Install male 1/2” flare adaptor at the 1/2” NPT

internal thread of the range inlet. Use a backup

wrench on the elbow fitting to avoid damage.

2. Install male 1/2” or 3/4” flare union adapter on the

NPT internal thread of the manual shut-off valve.

3. Connect flexible metal appliance connector.

4. Make sure circuit breaker is off and then plug range

cord in to electrical outlet.

5. Push range back into position insuring that range

leg slides under the anti-tip bracket. The range will

sit 3/4” away from the wall when properly installed.

Note: Be careful not to crimp flexible connector!

6. Carefully tip range forward to insure that anti-tip

bracket engages and prevents tip-over.

Important note for LP users:  The range is

shipped from the factory for use with natural gas. For

use with propane (LP) gas, your range must first be

converted using the LP conversion kit.

Figure 5: Flexible Connector Method

Gas Shut-

Off Valve

Flexible

Connector

Regulator

Leak testing is to be conducted by the installer

according to the instructions given in this section.

Turn on Gas.  Apply a non-corrosive leak detection

fluid to all joints and fittings in the gas connection

between the shut-off valve and the range. Include gas

fittings and joints in the range if connections

 

may have

been disturbed during installation. Bubbles

If a leak appears, turn off supply line gas shut-off

valve and tighten connections. Retest for leaks by

turning on the supply line gas shut-off valve. When

leak check is complete (no bubbles appear), test is

complete. Wipe off all detection fluid residue. Proceed

to Step 6: Final Steps.

gas shut off

valve

elbow

nipple

nipple

nipple

union

elbow

1/2” to 3/4”

gas pipe

Figure  6: Rigid Pipe Method

elbow:

connect to

regulator here

The configuration of the rigid pipe connection will vary

depending on the location of the gas pipe stub. Refer to

Figure 6 for details.

1. Make sure circuit breaker is off and then plug range

cord in to electrical outlet.

2. Push range back into position insuring that range leg

slides under the anti-tip bracket. The range will sit

3/4” away from the wall when properly installed.

3. Carefully tip range forward to insure that anti-tip

bracket engages and prevents tip-over.

4. Connect pipe to range at union. Access the

connection through the access panel behind the

warming drawer.

Note: Be careful not to apply pressure to warming

drawer element during rigid pipe installation.

NEVER CHECK FOR LEAKS WITH A FLAME.

DO NOT CONTINUE TO THE NEXT STEP UNTIL

ALL  LEAKS ARE ELIMINATED.

Before you plug in an electrical cord, be sure all

controls are in the OFF position.