Whirlpool W10178072B 用户手册

Align the sides of the pedestal so that they are even with the 

sides of the washer/dryer. Reach inside the pedestal opening 

and securely tighten all four pedestal screws.

Tip the washer/dryer back to its upright position. Remove  

and discard any remaining packaging material.

Follow the installation instructions that came with your model  

to finish installing or reinstalling your washer/dryer (i.e., hoses, 

vents, etc.).
note: Be sure to remove the transport bolts from the back  

of the washer.

 Not Level

 Not Level

Place level here

Place a level on top edges of washer/dryer, checking each  

side and front. Rock washer/dryer back and forth to make  

sure all four feet make solid contact with floor. 

If not level, adjust pedestal feet up or down, repeating as  

necessary.

The pedestal arrives with the feet tight against the bottom  

of the unit. Using a 1/4" hex-head ratchet or open-end 

wrench, lower the feet approximately 1" (25 mm) away  

from the bottom of the pedestal.