Bolens 930 SWE 服务手册

Disconnect the chute crank assembly at the discharge 
chute end by removing the hairpin clip and the flat 
washer. Refer to Figure 7-1. 

Remove the plastic belt cover on the front of the 
engine by removing the three self-tapping screws. See 
Fig. 7-2.

Loosen the bolt shown in Figure 7-3 securing the belt 
keeper bracket and remove the other bolt. Push the 
belt keeper bracket up off the engine pulley. Refer to 
Figure 7-3.

1.

2.

3.

To remove and replace your snow thrower’s auger belt, 
proceed as follows:

Remove the hairpin clip and flat washer from the 
ferrule in order to disconnect the auger idler rod from 
the brake bracket assembly. See Figure 7-4.  
NOTE: Make sure to maintain the location of the ferrule 
on the idler rod. 

Slip the auger control belt (the front belt) off the 
engine pulley. 
Pull the brake bracket assembly towards the cable 
guide roller and unhook the auger cable “Z” fitting. 
Refer to Figure 7-5.

1.

2.

3.

Loosen

Remove