McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 用户手册

McDATA UltraNet Edge 3000 User Guide

This will reset the UltraNet Edge 3000 and bring up the 
maintenance IP address.

8. Using Windows Dial-up Networking, establish a PPP session 

from the local PC to the new UltraNet Edge 3000.

9. Using the most current version of UCM, display the network map 

created in the previous version of UCM. 

10. Start the Hardware Replacement Wizard by right-clicking on the 

UltraNet Edge 3000 node>Tools>Replace Node (Hardware 
Replacement)

 for the new UltraNet Edge 3000. 

11. Update the serial number and license information.

12. Deliver the configuration to the new UltraNet Edge 3000. 

Use the following procedure to FTP to the new UltraNet Edge 3000 
and retrieve the new software:

1. Telnet to the new UltraNet Edge 3000 and issue the 

command. 

This will boot up the UltraNet Edge 3000 and invoke the new 
configurations.

2. Telnet to the UltraNet Edge 3000 that is currently running OS 

3.1.1.1 (or any subsequent OS 3.x.x.x version).

Where xxx = the version of the UltraNet Edge 3000 before the 
upgrade.

3. Issue the 

 (where x = circuit ID 1, 2, etc) command 

for every defined circuit.

4. Issue the following commands:

— Edge> 

  

(where xxx.xxx.xxx.xxx = the IP WAN address of the new 
UltraNet Edge 3000) 

— Name  <xxx.xxx.xxx.xxx>: press 

— Password: xxxxxxxx  

(where xxxxxxxx = the proper password)

A successful FTP login should occur. 

5. The output to the screen should read, “Using binary mode to 

transfer files”. If not, issue the 

 command at the FTP 

prompt.