M-Systems Flash Disk Pioneers Flash Memory 45-SR-001-01-7L 用户手册

  

FFD 3.5" SCSI Flash Disk User Manual 

45-SR-001-01-7L REV 4.0 

17 of 22

 

The problems that arise in most installations are described below. 

This occurs when there is a passive termination with Fast-SCSI devices on the bus. 

This occurs when there are too many devices terminated, or when the SCSI bus cable ends are not 
terminated. 

Avoid using homemade, short, flat ribbon cables with bad contacts or cheap cables. Do not mix 
round cables with flat cables. 

Ensure that the cable length is within the limit specified in the standard, and avoid using cables that 
are too long to support the transfer rate. 

This occurs when a new device is added with a SCSI ID identical to an existing device on the bus. 

This occurs when the host adapter or at least one of the devices on the SCSI bus does not supply 
termination power. 

Some host adapters do not install support for SCSI drives as an expansion BIOS. In this case, load an 
additional driver for your operating system after the system boots. Note that this configuration cannot 
boot from the SCSI drive.