Lanner electronic FW-7890 用户手册

 

This selection will cause the system to turn off the vertical and 

horizontal synchronization ports and write blanks to the video buffer.

Blank Screen  This option only writes blanks to the video buffer. 

Initial display power management signaling. 

Select the Suspend Type.Configuration options: PWRON Suspend / Stop Grant 

When enabled and after the set time of system inactivity, all devices except the CPU 
will be shut off. Configuration options: Disabled / 1 Min / 2 Min / 4 Min / 8 Min / 12 
Min / 20 Min / 30 Min / 40 Min / 1 Hour . 

When enabled and after the set time of system inactivity, the hard disk drive will be 
powered down while all other devices remain active.  
Configuration options: Disabled / 1 Min / 2 Min / 3 Min / 4 Min / 5 Min / 6 Min / 7 Min 
/ 8 Min / 9 Min / 10 Min / 11 Min / 12 Min / 13 Min / 14 Min / 15 Min 

Soft-Off by PWR-BTTN : When set to delay 4 sec, the function allows the power button to 

put the system in Suspend, a power saving mode. When set to Instant-off  the Soft-Off 
by PWR-BTTN function is disable and the computer turns completelyoff when the 
power button is pressed. 

Wake-Up by PCI  card: Enable this selection to use the Wake up by PCI card. 

You can set "Resume by Alarm" item to enabled and key in Data/ time to power on 
system. 

Disable this function. 

Enable alarm function to POWER ON system. 
 
If RTC Alarm Lead To Power On is Enabled. 
 
Date (of Month  ) Alarm : Every day , 1~31 
Time (hh: mm: ss) Alarm : (0~23) : (0~59) : (0~59) 

Configuration options: Enabled / Disabled 
 

PWRON After PWR-Fail : Select Enabled, this setting will let the power switch always 
under on-line status after commercial power back to normal.