Monogram ZV830SMSS 手册

FAN FAILS TO CIRCULATE  • Check to be sure the metal grease filter and the charcoal filter 
AIR OR MOVES AIR 

(if present) are clean. Clean the metal grease filter (see the Metal 

grease filter section) and, if the hood is recirculated (not vented to the 
outside), replace the charcoal filter (see the Charcoal filter section). 
If cleaning and replacing the filters does not correct the problem, 
call for service.

• The motor is probably overheating and turning itself off. This can 

be harmful to the motor. Check to be sure the filter is clean and 
check ductwork for blockage. If off and on cycling continues, call 
for service.

• Light(s) were replaced with bulbs with greater than the 120 volt, 50 

watt limit. Replace with the correct type and size bulb. See the 

Light bulbs section. 

• Use 120 volt, 50 watt, MR16 halogen bulbs with a GU10 base and 

make sure they are inserted securely. It is important to replace with 
bulbs that do not exceed the recommended wattage. Higher wattage 
bulbs will cause the outer rings to blink, and the lights will not 
function at the highest levels. See the Light bulbs section.

• Disconnect power to the hood by turning the circuit breaker off or by

removing the fuse in the home fuse box. Wait 30 seconds to allow the 

hood controls to reset and then replace the fuse or move the circuit 
breaker back on.

• So that you can easily set the controls to the desired setting, the hood 

is designed for the light and fan buttons to cycle through the settings.

This is normal.

• For your convenience, it is normal for the lights and fan to remember 

their last setting when you press the Memory/Off button. If you 

want only the lights on, press the “FAN +” (or the “FAN –” ) button to 

turn the fan off. When you power the hood up next time, only the 

lights will function. NOTE: You may turn the fan and lights off or on 
separately, using the “+” or “–” buttons.

The Problem Solver

9