Prestige UIB52NB 手册

1.) Choose an installation height comfortable for the user. IMPORTANT: Most building codes require a 30" 
clearance from the top of a surface burner to the underside of any combustible material. 

2.) Choose the appropriate cut-out dimension from the enclosed planning guide. Mark the underside of the wood
hood, alcove, or hearth making sure you leave adequate clearance for the stainless steel trim overlay and body
of the hood liner. Cut along your marked line. 

3.) Caution: SWITCH POWER OFF AT SERVICE PANEL. Insert 115 volt line through the 7/8" hole that is punched
through the back of the unit and attach with the appropriate ROMEX or BX connector.

4.) Attach the metal duct to the unit either directly to the collar provided or by using a duct transition. See chart B.
NOTE: USE RIGID METAL DUCTWORK ONLY. DO NOT ATTEMPT TO USE FLEXIBLE DUCT OR PLASTIC DU
FLOW RESTRICTIONS AND GREASE BUILD UP WILL OCCUR.

5.) Lift hood liner into position. Fasten to underside of the wood hood, alcove or hearth with appropriate fastener.
Make certain the unit is fastened securely to prevent vibration. 

6.) Complete the electrical connection in the junction box inside the hood. If equipped with internal fan check to be
certain that the fan blade turns freely by hand and there are no packing materials or other obstructions in the motor
housing. Also, make sure light bulbs are tightly screwed into sockets.

7.) Install stainless steel filters by sliding filters into the top channel then down into the lower channel. 

8.) Turn power on at service panel. 

6