Bosch HBL8451UCX 说明手册

English 4

Note: Only align the side hinge oven doors after the unit is 
fully installed into the cabinet.

1. Check to see if the 

side hinge oven doors 
are properly aligned.
The door should pull 
itself closed smoothly 
when the striker 
engages the roller as 
the door is closed.

2. Too high (Fig. A - door 

needs to move down 
on latch side) you will 
feel interference 
between the striker 
and the catch receiver.

3. Too low (Fig. B - door 

needs to move up on 
latch side) you will feel 
a bump when the 
striker comes into 
contact with the re-
alignment roller.
Hint: The gap between 
the top of the closed 
oven door and the 
control panel (or upper 
door for lower cavities 
in double ovens) 
should be fairly 
uniform from side to 
side. 

1. Open the door to 

approximately 135°.

2. Using a Torx T-20 star-

head screwdriver, 
loosen the 3 screws 
(A) on the lower hinge 
by 1 to 2 full turns.
Note: All adjustment is 
made with the lower 
hinge only. The upper 
hinge is fixed in place 
and cannot be 
adjusted.

3. Using a #2 philips 

head screwdriver, turn 
the cam (B) right or left 
to adjust the hinge 
position in the desired 
direction.
Note: 1mm of hinge 
movement (left or 
right) will move the 
door up or down 
approximately 1.5mm 
at the door catch.

4. Re-tighten the screws 

before closing the 
door to test. Be careful 
not to overtighten.

5. Check for proper door 

alignment. Repeat 
adjustment procedure 
as necessary.