Frigidaire FFFW5000QW 安装指导

4

Drain hose attached to the washer can reach a 74 in. 

(188 cm) high standpipe. For higher standpipe, use 

hose P/N 137098000, available from an authorized 

parts distributor. 

GFI (Ground Fault Interrupter) receptacle is not 

required.

Because of potentially inconsistent voltage capabilities, 

the use of this washer with power created by gas 

powered generators, solar powered generators, wind 

powered generators or any other generator other than 

the local utility company is not recommended.

CIRCUIT -  Individual, properly polarized and grounded 

15 amp. branch circuit fused with 15 amp. time delay 

fuse or circuit breaker.

POWER SUPPLY - 2 wire, with ground, 120 volt single 

phase, 60 Hz, Alternating Current.

OUTLET RECEPTACLE - Properly grounded 3-prong 

receptacle to be located so the power supply cord is 

accessible when the washer is in an installed position.

Grounding type

Grounding type
wa

wall receptacl

ll receptacle

Po

Power cord with

wer cord with

3-prong 

3-prong  gr

grounded plug

ounded plug

  1  Drain capable of eliminating 17 gals (64.3 L) per 

minute.

  2  A standpipe diameter of 1-1/4 in. (3.18 cm) 

minimum.

  3  The standpipe height above the fl oor should be:

Minimum height:   24 in. (61 cm)

Maximum height:  96 in. (244 cm)

Hot and cold water faucets MUST be installed within hose 

length of your washer’s water inlet. The faucets MUST 

be 3/4 inch (1.9 cm) with threading for laundry hose 

connection. Water pressure MUST be between 30 and 

120 psi. Pressure difference between hot and cold cannot 

be more than 10 psi. Your water department can advise 

you of your water pressure.

  1  The washer MUST be grounded. In the event of 

malfunction or breakdown, grounding will reduce 

the risk of electrical shock by a path of least 

resistance for electrical current.

  2  Since your washer is equipped with a power supply 

cord having an equipment-grounding conductor 

and a grounding plug, the plug MUST be plugged 

into an appropriate, copper wired receptacle that is 

properly installed and grounded in accordance with 

all local codes and ordinances or in the absence 

of local codes, with the National Electrical Codes, 

ANSI/NFPA 70 (latest edition). If in doubt, call a 

licensed electrician. DO NOT cut off or alter the 

grounding prong on the power supply cord. In 

situations where a two-slot receptacle is present, 

it is the owner’s responsibility to have a licensed 

electrician replace it with a properly grounded three 

prong grounding type receptacle.

Improper connection of the equipment grounding 

conductor can result in a risk of electrical shock. Check 

with a licensed electrician if you are in doubt as to 

whether the appliance is properly grounded.