Vinotemp VT48TS 业主指南

 

10 

 

 

You can solve many common wine cellar problems easily, saving you the cost of a possible service call. Try 
the suggestions below to see if you can solve the problem before contacting Vinotemp at info@vinotemp.com. 

Door will not close 
properly. 

•  The wine cellar is not level. 

•  The shelves are out of position. 

•  The door was reversed and not properly installed. 

•  The door gasket is dirty. 

•  A bottle in the cellar is too long. 

Unit does not 
operate—does not 
have power. 

•  Check that unit is plugged into the wall socket. 
•  Make sure the wall socket has power. If outlet is controlled by a 

wall switch, make sure switch is set to on. Test wall socket 
functionality by testing another electrical appliance in the power 
socket. 

Power is ON but the 
unit will not cool. 

•  Make sure there are at least 3 to 5 bottles in the unit. When using 

the unit for the first time, it can take up to 24 hours to reach the 
desired temperature. 

•  If the room temperature is at the high end of the ambient 

temperature range, it may have more difficulty achieving a low 
internal temperature. 

•  To achieve accurate temperature control, the unit should not be 

used or operated in any of the following locations: 
o

  In a sunny place, a room with poor air circulation such as a 

garage or near another heat-producing appliance such as a 
dishwasher, oven or refrigerator. 

o

  With an outlet shared with a refrigerator, as the refrigerator will 

drain power from the wine cellar. 

•  Make sure the cooler has proper clearances at side and rear and is 

located in a well-ventilated area. 

•  Door is not closed tightly or is being opened too frequently. 

Fan is always 
running. 

•  This is simply a function of the cooling system. The lower the 

setting, the more the fan will run. If the room is very warm, the 
cooler will run more. 

•  The unit has been designed to run continuously when operating at 

the lower temperatures. 

Vibrations 

•  Check to make sure the wine cellar is level. 

Frost appears in 
cabinet (on back). 

•  Either too much humidity or too low of temperature inside cooler. 

Unplug cooler and allow to manually defrost. Reconnect when ice 
has melted. If problem persists, contact the manufacturer for 
service instructions. 

Inside light flashes. 

•  In some instances, this is normal. The light may flash when the 

automatic defrost function starts to work. 

•  Set temperature is higher than interior temperature. Adjust 

temperature to resolve.