Frigidaire FGMC2765P 业主指南

45

The door is heavy. For safe, temporary storage, lay the 

door fl at with the inside of the door facing down.

Be sure the oven is unplugged and all parts are COOL 

before replacing the oven light bulb. Do not turn the oven 

light on during a self-cleaning cycle. High temperature 

will reduce lamp life.

1.  Open oven door completely (horizontal with fl oor- 

See Figure 1).

2.  Pull the door hinge locks on both left and right 

door hinges down from the oven frame completely 

towards the oven door (See Figure 2). A tool such as 

a small fl at-blade screwdriver may be required.

3.  Firmly grasp both sides of oven door along the door 

sides (Do not use the oven door handle- See Figure 3).

4.  Close the door to the broil stop position (the oven 

door will stop into this position just before fully 

closing).

5.  With the oven door in the broil stop position, lift the 

oven door hinge arms over the roller pins located on 

each side of the oven frame (See Figure 4).

1.  Firmly grasp both sides of oven door along the door 

sides (Do not use the oven door handle- See Figure 3).

2.  Holding the oven door at the same angle as the 

removal position, seat the hook of the hinge arm over 

the roller pins located on each side of the oven door 

frame (See Figure 4). The hook of the hinge arms 

must be fully seated onto the roller pins.

3.  Fully open the oven door (horizontal with fl oor- See 

Figure 1).

4.  Push the door hinge locks up towards and into the 

oven frame on both left and right oven door hinges 

(See Figure 2) to the locked position.

5.  Close the oven door.

Door Hinge locations with 

oven door fully open

Oven door

Around

Hinge

Special Door Care Instructions - Most oven doors 

contain glass that can break. 

Read the following recommendations:

1.  Do not close the oven door until all the oven racks 

are fully in place.

2.  Do not hit the glass with pots, pans, or any other 

object.

3.  Scratching, hitting, jarring or stressing the glass may 

weaken its structure causing an increased risk of 

breakage at a later time.

The oven light bulbs are located at the rear of the oven 

cavity and are covered with a glass shield. The glass 

shield must be in place whenever the oven is in use.
To Replace the Light Bulb:
1.  Turn electrical power off at the main source or unplug 

the appliance.

2.  Remove lower oven interior light shield by turning a 

quarter turn counter-clockwise.

3.  Replace bulb with a new T-4 type 40 Watt Halogen 

appliance bulb. 

Please note: do not allow your fi ngers to touch the new 

bulb when replacing. This will shorten the life of the new 

bulb. Use a paper towel to cover the new bulb when 

installing.
4.  Replace glass shield 

over bulb by rotating 

clockwise.

5.  Turn power back on 

again at the main 

source (or plug the 

appliance back in).

6.  The clock will then 

need to be reset.

LOCK