Whirlpool WET4027EW 安装指导

Prop up the front of the washer/dryer  

about 4" (102 mm) with a wood block  

or similar object that will support the  

weight of the washer/dryer. Then screw the locknut onto each 

foot to within 1" (25 mm) of the foot base.

Screw the feet into the threaded holes at  

the front corners of the washer/dryer until  

the jam nuts touch the washer.
NOTE: Do not tighten the nuts until the washer/dryer is level.
Tilt the washer/dryer back and remove the wood block. Gently 

lower the washer/dryer to the floor.

Install Leveling Legs (27" models) Install Leveling Legs (24" models)

To protect the floor, use a large flat piece of cardboard from the 

shipping carton. Gently place the washer/dryer on its side, on  

the cardboard.

Push legs into holes in rear corners until they snap into place.  

Check adjustability of rear legs by pushing in one leg. The 

other leg should come out. Check both legs. If they do not 

move freely, repeat procedure.

Examine front leveling legs; find diamond marking. Screw front 

legs by hand into holes in triangular braces in front corners. 

Use wrench to finish turning the legs until diamond marking is 

no longer visible. Gently stand the washer/dryer upright.

Open the washer lid. The latch under the dryer will keep  

the lid open. Pull the foam packing ring out of the washer. 

NOTE: Keep the foam ring and use it when transporting  

your washer/dryer. This packing material is used to keep  

the washer tub stable during transport.

Remove Foam Packing (24" models)