Whirlpool WET4027EW 安装指导

Connect Drain Hose

Check the drain hose to see whether it is the proper length.

Wet the inside of the straight end of the drain hose with tap

water.
IMPORTANT: Do not use any lubricant other than water. 
Squeeze ears of the silver double-wire clamp with pliers to 

open. Place clamp over the straight end of the drain hose 1/4" 

(6.4 mm) from the end.

Place hose into standpipe (shown in picture) or over side of   

laundry tub.

IMPORTANT: 4.5" (114 mm) of drain hose should be inside  

standpipe; do not force excess hose into standpipe or lay  

on bottom of laundry tub. Drain hose form must be used.

Drain

hose form

Open clamp. Twist hose back and forth while pushing onto

drain connector on the side of the washer/dryer. Continue until

hose contacts the ribbed stops on the cabinet. Place clamp 

over the area marked “CLAMP.” Release clamp.

Proper connection of the drain hose protects your floors  

from damage due to water leakage. To keep the drain hose  

from coming off or leaking, it must be installed according  

to the following instructions:
IMPORTANT: To ensure proper installation, this procedure  

must be followed exactly.

For floor drain installations, you will need to remove the drain 

hose form from the end of the drain hose. You may need  

additional parts with separate directions. See “Tools and Parts.”