Frigidaire FFGC3610QS 业主指南

下载
页码 10
8
CARE & CLEANING 
(Cleaning Chart)
CLEANING VARIOUS PARTS OF YOUR COOKTOP
Before cleaning any part of the cooktop, be sure all controls are turned OFF and the cooktop is COOL. REMOVE 
SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANING WILL REDUCE THE NUMBER OF 
MAJOR CLEANING LATER.
Surfaces
How to Clean
Aluminum (Trim Pieces) & 
Vinyl
Use hot, soapy water and a cloth. Dry with a clean cloth. 
Glass, Painted and Plastic 
Control Knobs, Body 
Pieces, and Decorative 
Trim
Using a soft cloth, clean with mild dish detergent and water or a 50/50 solution of 
vinegar and water. Follow by rinsing the area with clean water; dry and polish with a 
soft cloth. Glass cleaners may be used if sprayed on a soft cloth fi rst. DO NOT spray 
liquids directly on the control pad and display area. Do not use large amounts of 
water on the control panel - excess water on the control area may cause damage to 
the appliance. Do not use other liquid cleaners, abrasive cleaners, scouring pads, or 
some paper towels - they will damage the fi nish.
Control Panel
Wipe the control panel clean after each use. Before cleaning the control panel, turn 
all controls to OFF and remove the control knobs. To remove, pull each knob straight 
off the shaft. Clean using hot, soapy water and a cloth. Be sure to squeeze excess 
water from the cloth before wiping the panel; especially when wiping around the 
controls. Excess water in or around the controls may cause damage to the appliance. 
To replace knobs after cleaning, line up the fl at sides of both the knob and the shaft; 
then push the knob into place.
Stainless Steel, Chrome 
Decorative Trim (some 
models)
Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean water 
and a cloth. Do not use cleaners with high concentrations of chlorides or 
chlorine. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are 
especially made for cleaning stainless steel. Always be sure to rinse the cleaners 
from the surface as bluish stains may occur during heating that cannot be removed.
Porcelain Enamel
Burner Grates, Burner Rings 
(some models), Cooktop 
Surface (some models)
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 
1:1 solution of clear water and ammonia. If necessary, cover diffi cult spots with 
an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and 
a damp cloth, and then scrub with a soap-fi lled scouring pad. Rinse and wipe dry 
with a clean cloth or paper towel. Remove all cleaners or the porcelain may become 
damaged during future heating. DO NOT use spray oven cleaners on the cooktop.
CLEANING THE COOKTOP, BURNER CAPS 
& GRATES
The cooktop is designed to make cleaning easier. Because 
the gas Burners are sealed, cleanups are easy when 
spillovers are cleaned up immediately. 
The cooktop, Burner Heads and Caps should be routinely 
cleaned. Keeping the Burner Head Ports clean will 
prevent improper ignition and an uneven fl ame. Refer to 
the following instructions:
IMPORTANT
THE COOKTOP IS NOT REMOVABLE. Do not 
attempt to remove or lift the cooktop.
CAUTION
Pay attention to not damage electrodes. Damaged 
electrodes may cause a delayed ignition or prevent the 
burner from igniting.
CAUTION
Any additions, changes or conversions required in order 
for this appliance to perform satisfactorily must be 
made by an authorized Service Center.
CARE & CLEANING