Frigidaire FFGC3610QB 安装指导

下载
页码 28
GAS COOKTOP INSTALLATION INSTRUCTIONS
(For 30" & 36" Models)
6
To clamp down, insert an angle bracket into the slot 
on each side of the unit as shown. Run thumb screw 
up through the bracket, up against the bottom of the 
counter. Tighten until the unit draws down and is secure.
3. Provide an Adequate Gas Supply
This cooktop is designed to operate on natural gas at 5" 
of manifold pressure only.
A pressure regulator is connected in series with the 
manifold on the cooktop and must remain in series with 
the supply line.
For proper operation, the maximum inlet pressure 
to the regulator must be no more than 14" of water 
column (W.C.) pressure.
For checking the regulator, the inlet pressure must be at 
least 1" (or 2.5 kPa) greater than the regulator manifold 
pressure setting. The regulator is set for 5" of manifold 
pressure, the inlet pressure must be at least 6".
The gas supply line to the range should be 1/2" or 3/4" 
pipe.
4. LP/Propane Gas Conversion
This appliance can be used with Natural gas or LP/
Propane gas. It is shipped from the factory for use with 
natural gas.
A kit for converting to LP gas is supplied with your 
cooktop. The kit is marked "FOR LP/PROPANE GAS 
CONVERSION".
The conversion must be performed by a qualifi ed service 
technician in accordance with the kit instructions and 
all local codes and requirements. Failure to follow 
instructions could result in serious injury or property 
damage. The qualifi ed agency performing this work 
assumes responsibility for the conversion.
 Failure to make the appropriate conversion 
can result in serious personal injury and property 
damage.
Important: Remove all packing material and literature 
from cooktop before connecting gas and electrical 
supply to cooktop.
1. Wall Outlet Location
Figure 5
2. Cooktop Installation 
1. Visually inspect the cooktop for damage.
2. Set the cooktop into the countertop cutout.
After inserting the cooktop into the countertop 
opening, make sure the unit is sitting on the metal 
fl ange around the top of the burner box. Cooktop 
must not sit on the glass or the porcelain top. Avoid 
cutting an oversized hole in the countertop.
NOTE: Do not use caulking compound; cooktop should 
be removable for service when needed.
Clamp Down Information
Once the cooktop is installed in the counter opening, 
you must clamp the unit down as shown.
Figure 6
Countertop
Cooktop (Glass 
or Porcelain)
Angle 
Bracket
Seal (Porcelain 
Cooktop Only)
Thumb 
Screw