Amana NED4655EW 用户手册

 

■

Must be at least 12" (305 mm) from ground or any object that 

may obstruct exhaust (such as flowers, rocks, bushes, or 

snow).

 

■

45° elbows provide better airflow than 90° elbows.

 

■

Use clamps to seal all joints.

 

■

Exhaust vent must not be connected or secured with screws 

or other fastening devices that extend into interior of duct  

and catch lint. Do not use duct tape.

See “Venting Kits” for more information.

To reduce the risk of fire, this dryer MUST BE 

EXHAUSTED OUTDOORS.

Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent, 

chimney, wall, ceiling, attic, crawlspace, or a concealed space 

of a building. Only rigid or flexible metal vent shall be used for 

exhausting.

 

■

Only a 4" (102 mm) heavy metal exhaust vent and clamps 

may be used. 

 

■

Do not use plastic or metal foil vent.

 

■

Recommended for best drying performance and to avoid 

crushing and kinking.

(Acceptable only if accessible to clean)

 

■

Must be fully extended and supported in final dryer location.

 

■

Remove excess to avoid sagging and kinking that may result 

in reduced airflow and poor performance.

 

■

Do not install in enclosed walls, ceilings, or floors.

 

■

The total length should not exceed 7

3

/

4

 ft. (2.4 m).

If using an existing vent system, clean lint from entire 

length of the system and make sure exhaust hood is not 

plugged with lint. Replace plastic or metal foil vents with rigid 

metal or flexible metal vents. Review “Vent System Chart” and, 

if necessary, modify existing vent system to achieve best drying 

performance.