Whirlpool XHPC155YBD 安装指导

Place level here

Place a level on top edges of  

washer/dryer, checking each side  

and front. Rock washer/dryer back and forth to make sure all  

four feet make solid contact with floor. 

If not level, adjust pedestal feet up or down, repeating as  

necessary.

Locate the 1/4" hex-head screws on the top of each pedestal 

foot. Reach inside the pedestal and use a 1/4" hex-head  

ratchet or open-end wrench to adjust the feet up or down  

as needed, to level the washer/dryer.
note: Make sure all four pedestal feet are in solid contact  

with the floor. 

When the washer/dryer is level, use a 9/16" open-end wrench  

to securely tighten all four jam nuts against the pedestal.
ImPoRtant: The jam nuts must be tightened to avoid 

vibration.

Pull both drawer slides out and reassemble the drawer to  

the drawer slides with the two hex-head screws.

Remove the shipping film from the drawer.  

Place the divider in the drawer at the desired  

location. Close the drawer. 
note: Use of the divider is optional.

Not Level

Not Level