Verona VECTGM305SS 安装指导

 

 

16

 

IZED SERVICER (or other qualified agency) in 

accordance with the manufacturer's instructions 

and all codes and requirements of the authority 

having jurisdiction. Failure to follow instructions 

could result in serious injury or property damage. 

The qualified agency performing this work as-

sumes responsibility for this conversion. 

 

prior to conversion. 

 

If this appliance should be converted for use with gas 

LP (propane or butane), each of the following modifi-

cation must be performed: 

1.  Remove the grates and burner cups. 

2.   Remove aluminum gas spreader. 

3.   Loosen injector by turning 9-32” nut driver counter 

clockwise. 

4.   Install the injectors supplied with this appliances in 

the appropriate burner. The injectors have small 

number stamped on the side, this number codes 

the orifice diameter and its correct burner location 

(see figure on page 18). 

5.   Turn clockwise to tighten (tighten to a torque of 15 

to 20 inch-lbs). 

6.   Replace all parts following the reverse order. 

7. 

 

 

 

1.  Remove the grates and burner cups. 

2.  Remove aluminium gas spreader. 

3.  Remove the three screws of simmer gas spreader 

(1). 

4.  Remove the two screws of injector cover (2). 

5.  Loosen injector (A) by turning 9-32” nut driver 

counter clockwise. 

6.  Loosen injector (B) by turning 9-32” box wrench 

counter clockwise. 

7.  Install the injectors supplied with this appliances  

in the appropriate burner. The injectors have small 

number stamped on the side, this number codes 

the orifice diameter and its correct burner location 

(see figure of the paragraph “Injectors position”). 

8.  Turn clockwise to tighten (tighten to a torque of 15 

to 20 inch-lbs). 

9.  Replace all parts following the reverse order. 

10. 

ances for future use.