Friedrich SS12N10B 安装指导

20

FRR080

30°

45°

60°

30°

45°

60°

25ft

25ft

8ft

4ft

25ft

16ft

6ft

30°

30°

45°

60°

45°

60°

25ft

25ft

25ft

8ft

25ft

25ft

7.5ft

Remote Control - Refer to Figures 12 and 13 during operation description.

Getting Started - Install two (2) AAA batteries in the battery compartment 
located on the back of the unit.

Operation  -  The  remote  control  should  be  within  25  feet  of  the  air 
conditioner for operation.  (Refer to Figure 11 for effectiveness). Press the 
power button to turn the remote on. The remote will automatically power 
off after 15 seconds if the buttons are not being pressed. The remote must 
be on to control the unit.

POWER Button - Turns remote and unit on and off.

SYSTEM Button - Allows the user to sequentially select the  

, HEAT 

, and FAN ONLY 

following:  AUTO  - AUTO -, COOL  

operations. When the button is pressed, the display indicates which mode 
has been selected via a display message.Note  that  when  the  heating   

automatically skip the HEAT mode.

FAN MODE Button - Selects between automatic (

) or 

 

operation.  In the 

 mode, the fan only turns on and off when the 

compressor operates or the heat function is enabled.

NOTE: 

 is not available in the FAN ONLY Mode, the display 

indicates 

.  In the 

 mode, fan speed is 

determined by your selection on the 

 button.

FAN SPEED Button - Used to sequentially select new fan speed, plus 
AUTO operation. When the 

 button is pressed, the fan speed icon 

(triangle) changes to indicate the new speed level.  Fan speed automatically 
varies depending on the set temperature on the control panel and the actual 
room temperature.  For example if there is a big difference between your 
set temperature and the actual room temperature, the system fan speed 
increases to HIGH.  It remains at this speed until the room temperature 
matches the set temperature.

SCHEDULE Button – The 

 button turns the schedule  function 

on and off.  Press the Schedule button once to turn on the Schedule 
(Residential, Commercial, Timer, or Customized) that has already been 
selected on your unit.  Pressing the 

 button a second time turns 

the schedule  function off.

UP and DOWN Arrows - Pressing either the 

 (UP) or 

 (DOWN) 

button changes the desired room temperature.  The factory preset lower 
and upper limits are 60°F (16°C) and 99°F (37°C).  These buttons are also 
used to navigate between function options when using the User Menu or 
Maintenance Mode.

Hand Held Remote - Has an operating range of up to 25 ft. The infrared 
remote control signal must have a clear path to transmit the command to 
the air conditioning unit. The remote signal has some ability to "bounce" 
off of walls and furniture similar to a television remote control. The diagram 
below shows the typical operating range of the control in a standard room 
with 8 ft high ceilings.

function is not available, the system will