Viking VGRT5364G 安装指导

Electrical & Gas Requirements

1-1/2”

(3.8 cm)

24” max.

(

61.0 cm)

25” max.

(

65.4 cm)

3”

(7.6 cm)

Electrical Requirements

There is no connection necessary beyond

plugging the unit into a polarized,

grounded, 120 volt, 60 Hz, 15 amp circuit.

The minimum of 102 VAC is required for

proper operation of gas ignition systems.

This circuit MUST be grounded and properly

polarized. The unit is equipped with a 16-

SPT2 power cord.

Gas Connection

The gas supply (service) line must be the

same size or greater than the inlet line of the

appliance. This rangetop uses a 1/2” (1.3

cm) ID NPT (Sch40) inlet. Sealant on all pipe

joints must be resistive to LP gas.

The rangetop is designed specifically for
natural gas or liquid propane (LP) gas.
Before beginning installation, verify that
the model is compatible with the intended
gas supply.

Manual shut-off valve:

This installer-supplied valve must be installed

in the gas service line before the appliance

in the gas stream and in a location where it

can be reached quickly in the event of an

emergency. Any opening behind the

rangetop should be sealed.

In Massachusetts:

A “T” handle type

manual valve must be installed in the gas

supply line to the appliance.

IMPORTANT: Any conversion required
must be performed by your dealer or a
qualified licensed plumber or gas service
company. Please provide the service person

with this manual before work begins.

Pressure Regulator:

• All heavy-duty, commercial type cooking

equipment must have a pressure regulator

on the incoming service line for safe and

efficient operation, since service pressure

may fluctuate with local demand. External

regulators are not required on this

rangetop since a regulator is built into

each unit at the factory. Under no

condition bypass this built-in regulator.

• Manifold pressure should be checked with

a manometer, natural gas requires 5.0”

W.C.P. and LP gas requires 10.0” W.C.P.

Incoming line pressure upstream from the

regulator must be 1” W.C.P. higher than

the manifold pressure in order to check

the regulator. The regulator used on this

range can withstand a maximum input

pressure of 1/2” PSI (14.0” W.C.P.). If the

line pressure is in excess of that amount, a

step down regulator will be required.

• The appliance must be disconnected from

the gas supply piping system during any

pressure testing of that system.

WARNING

ELECTRICAL SHOCK

HAZARD

To avoid the risk of electrical
shock, personal injury or death;

verify electrical power is turned off at the
breaker box and gas supply is turned off
until the rangetop is installed and ready
to operate, installation by an authorized
installer only.

Flexible Connections:

If the unit is to be installed with flexible

couplings and/or quick-disconnect fittings,

the installer must use a heavy-duty AGA

design-certified flexible connector of at least

1/2” (1.3 cm) ID NPT (with suitable strain

reliefs) in compliance with ANSI Z21.41

and Z21.69.

In Canada:

CAN 1-6, 10-88 metal

connectors for gas appliances and CAN

1-6.9 M79 quick disconnect devices for use

with gas fuel.

In Massachusetts:

This appliance must be

installed with a 36” (3-foot) long flexible

gas connector.