Amana PTH123G35CXXX 目录
CT-DPTAC
www.amana-ptac.com
3
s
Tandard
F
eaTures
(
conT
.)
• Condensate Dispersion System: Our condensate dispersion system removes condensate from indoor cooling operation
by throwing water directly on to the outdoor coil for rapid evaporation and increased cooling efficiencies. The slinger ring
on the new, enhanced fan draws water up and into the fan blades. This water is then atomized and evaporated into the
atmosphere through the condenser. Increased surface area from the coil allows more water to be evaporated on the sides
of the coils and helps to minimize condensate run-off.
on the new, enhanced fan draws water up and into the fan blades. This water is then atomized and evaporated into the
atmosphere through the condenser. Increased surface area from the coil allows more water to be evaporated on the sides
of the coils and helps to minimize condensate run-off.
• Front Desk Control: Each unit comes equipped with the DigiSmart™ control and energy management software. Using the
DigiSmart™ software and optional RF Antenna, all units can be wirelessly connected to a central hub for enhanced energy
savings and diagnostics. Amana brand PTACs also have a low-voltage interface capability with a field-supplied front-desk
ON/OFF switch. (See Page 4.)
savings and diagnostics. Amana brand PTACs also have a low-voltage interface capability with a field-supplied front-desk
ON/OFF switch. (See Page 4.)
• Room Freeze Protection: When the unit senses temperatures of 40°F or below, the unit activates the fan motor and either
the electric resistance heater or the hydronic heater.
• Easy-to-use Controls: No complex controls to confuse your guests and create phone calls for your manager. Controls are
easy to read, understand, and activate. Our new 7-button control panel provides guests with complete control of the unit
for their in-room comfort while maintaining overall energy efficiency.
for their in-room comfort while maintaining overall energy efficiency.
• Easy to Service with On-Board LED Diagnostics: The main components are easily serviced and there is no guessing to
determine the problem with our easy-to-read diagnostics.
• Stonewood Room Front: Our Stonewood room front strikes the balance between attractive styling and practical design.
Distinctive contours and a modern appearance enhance the character of even the most luxurious room, while the sleek 7⅝”
depth maximizes usable space for your guests.
depth maximizes usable space for your guests.
• Remote Thermostat Control: When the DigiSmart™ wireless remote thermostat (DS01E, sold separately) is set up, both the
remote thermostat and unit control panel continue to control the unit, providing flexibility and home-like system control.
Installation requires no more than pressing two buttons. No need to run wires or make electrical connections.
Installation requires no more than pressing two buttons. No need to run wires or make electrical connections.
• Remote Temperature Sensing: Guests enjoy ultimate comfort with consistent climate control. When the field-installed
thermistor (RTS03) is used, the unit-mounted thermostat is overridden to allow more accurate, internal wall-sensing of
room ambient temperature.
room ambient temperature.
• Extended Heat Pump Heating: Heat pump models will operate in the heating mode down to as low as 24°F outdoor
ambient temperature.
• Zero Floor Clearance: The unit can be installed flush to a finished floor, if desired. (Some accessories do not have zero clearance).
• 30-Second Fan-Off Delay: The fan continues to run 30 seconds after the compressor has stopped in either cooling or heat
• 30-Second Fan-Off Delay: The fan continues to run 30 seconds after the compressor has stopped in either cooling or heat
pump mode and after electric heat has been turned off. This improves efficiency by dispersing the conditioned air on the
coils into the room.
coils into the room.
• Compressor Lock-In: This feature helps prolong the life of the compressor by preventing short-cycling. When the compressor
is switched from Off to On because room temperature has risen or fallen below the specified limit, it will remain on for at
least 4 minutes. If the temperature set-point is changed during this 4 minutes, the lock-in feature is overridden.
least 4 minutes. If the temperature set-point is changed during this 4 minutes, the lock-in feature is overridden.
• Automatic Emergency Heat: No more “my unit is not heating” complaints during the middle of the night. Heat pump units
will automatically switch over to electric resistance heat if the heat pump compressor system fails or if the heating load is
greater than the unit capacity.
greater than the unit capacity.
• Constant Fan Mode: Take advantage of each unit’s dual options — select continuous fan operation or cycle the fan ON and
OFF with the thermostat. Our new 7-button design allows guests to select fan performance while allowing the owner to
have the unit revert to the desired program of continuous fan or cycle with conditioning.
have the unit revert to the desired program of continuous fan or cycle with conditioning.
• Hidden Ventilation Control: The ventilation control lever is hidden from the occupant's view to allow you to manage
ventilation requirements.
• High-Pressure Switch: Protects the unit from high pressure and damage to the unit, helping to ensure long unit life.