Frigidaire FFEW3025P 业主指南

 

Before you call for service, review the following list. It may save you time and expense. Possible solutions are provided 
with the problem listed:

Poor baking results

Many factors effect baking results. Use proper oven rack position. Center food in 
the oven and space pans to allow air to circulate. Preheat oven to the set tempera-
ture before placing food in the oven. Try adjusting the recipe's recommended 
temperature or baking time. See

 on 

 if 

you feel the oven is too hot or cold.

Oven does not operate.

The time of day is not set. The oven clock must first be set in order to operate the 
oven. 

Be sure oven controls are set properly. See 

on 

 and 

review instructions for the desired cooking function in this manual.

Service wiring is not complete. 

Oven light does not work.

Be sure the oven light is secure in the socket. See 

on 

Flames inside oven or smoking 
from oven vent. 

Excessive spills in oven. Grease or food spilled onto oven bottom or oven cavity. 
Wipe up excessive spills before starting oven. If flames or excessive smoke are 
present when using broil, see 

on 

Self clean does not work.

Oven control not set properly. Review 

on 

.

Oven racks discolored or do not 
slide easily.

Oven racks left in oven cavity during self clean. Always remove oven racks from 
oven cavity before starting a self-clean cycle. Clean by using a mild abrasive 
cleaner following manufacturer's instructions. Rinse with clean water, dry, and 
replace in oven.

Oven smokes excessively when 
broiling.

Incorrect setting. Follow broiling instructions in 

on 

. 

Meat too close to the broil element. Reposition broil rack to provide proper 
clearance between the meat and broil element. Remove excess fat from meat. Cut 
remaining fatty edges to prevent curling.

Grease build up on oven surfaces. Regular cleaning is necessary when broiling 
frequently. Grease or food splatters will cause excessive smoking.

Oven control panel beeps and 
displays any F or E code error.

Oven control has detected a fault or error condition. Press clear off to clear the 
error code. Try bake or broil function. If the F or E code error repeats, turn off power 
to appliance, wait 5 minutes and then repower appliance. Set clock with correct 
time of day. Try bake or broil function again. If fault recurs, press clear off to clear.

Soil not completely removed after 
self clean.

Self Clean was interrupted. Review instructions in Self Clean section.

Excessive spills on oven bottom. Clean before starting self clean.

Failure to clean soil from the oven frame, the door liner outside the oven door 
gasket, and the small area at the front center of the oven bottom. These areas are 
not in the self-cleaning area, but they get hot enough to burn on residue. Clean 
these areas before starting the self-cleaning cycle. Burned-on residue can be 
cleaned with a stiff nylon brush and water or a nylon scrubber. Be careful not to 
damage the oven gasket.