Summit SWC530LBISTADA 业主指南
4
INSTALLATION INSTRUCTIONS
Before Using Your Wine Cellar
Remove the exterior and interior packing.
Before connecting the wine cellar to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Install the handle on the left side of the door (see page 5).
Installation of Your Wine Cellar
This appliance is designed for free-standing or built-in (fully recessed) installation.
Place your wine cellar on a floor that is strong enough to support it when it is fully
loaded. To level your wine cellar, adjust the front leveling legs at the bottom of
the unit.
loaded. To level your wine cellar, adjust the front leveling legs at the bottom of
the unit.
Locate the wine cellar away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extremely cold ambient
temperatures may also cause the unit to perform improperly.
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extremely cold ambient
temperatures may also cause the unit to perform improperly.
Avoid locating the unit in moist areas.
Plug the wine cellar into an exclusive, properly installed and grounded wall outlet.
Do not under any circumstances cut or remove the third (ground) prong from the
power cord. Any questions concerning power and/or grounding should be
directed toward a certified or authorized products service center.
Do not under any circumstances cut or remove the third (ground) prong from the
power cord. Any questions concerning power and/or grounding should be
directed toward a certified or authorized products service center.
Reversing the Door Swing of Your Appliance
This appliance has the capability of the door opening from either the left or right
side. The unit is delivered to you with the door opening from the left side. Should
you desire to reverse the opening direction, please follow the instructions below:
side. The unit is delivered to you with the door opening from the left side. Should
you desire to reverse the opening direction, please follow the instructions below:
1. Carefully lay the wine cellar on its back. Use cushioning to protect the floor and
appliance.
2. With the door shut, remove the two screws holding the bottom hinge to the
door.
3. Carefully lift off the door.
4. Unscrew the top hinge pin and cover and move to the opposite side.