GE GDF610PGJBB 用户手册

For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be selected PRIOR to 

starting the cycle. The Steam option adds approximately 30 minutes to the cycle time. This option is  

(on some models) available 

with 

Heavy, AutoSense, and Normal cycles.

 

Selecting either the Upper or Lower Wash Zones will target dishwashing of just one rack. This will  

 

shorten the cycle time and conserve energy. This option can be used when there is only half a  

(on some models) 

load of dishes.

Delays the start of a wash cycle up to 12 hours, depending on model. Press Delay Hours, to select 

 

the number of hours, then press Start one time to begin countdown. The cycle will start once allotted time  

(on some models) has 

expired.

 

You can lock the controls to prevent selections from being made. You can also lock the controls 

after you have started a cycle to prevent cycle changes. For example, children cannot accidentally  

 

start the dishwasher by pressing pads with this option selected.

 

To LOCK the dishwasher control, depending on the model, press and hold the Heated Dry pad for 3 seconds or 

 

press and hold the Steam and Wash Temp pads at the same time for 3 seconds. The Control Lock light will turn 

 

on to indicate the control is locked. 

To UNLOCK the dishwasher control, depending on the model, press and hold the Heated Dry pad for 3 second  

 

or press and hold the Steam and Wash Temp pads at the same time for 3 seconds. The Control Lock light  

 

will turn off to indicate the control is unlocked.

 

Door can be open to select the desired options. Press the Start pad and close the door within 10 seconds  

 

 to start the cycle or begin the Delay Hours countdown. The wash cycle will begin shortly after closing  

the door. If the door is open, the illuminated lights will turn off if a pad is not pressed within two minutes.  

To activate the display, close and open the door or press any pad.

 

To interrupt or pause a dish cycle, slowly open the door. Opening the door will cause the wash cycle to

  

 

pause. The dishwasher will beep every minute to remind you to close the door. To restart or resume 

the cycle, press Start, and close the door.

To cancel a wash cycle, press and hold the Start pad for 3 seconds and close door. The dishwasher will drain,  

 

emit a beep sound, and the wash cycle light will turn OFF.

 

Displayed at the end of the cycle when Wash Temp Sani (Sanitize) has been selected and the dishwasher has met the  

 

requirements for sanitization. See Wash Temp Sani, for complete option description. Opening the door or pressing any  

 

key while the door is closed will turn off the light.

Displayed when a wash cycle is complete. The light stays ON as a reminder that the dishes are clean. Opening  

 

the door or pressing any key while the door is closed will turn the light off.

To turn this option ON/OFF, press and hold the START and WASH TEMP pads for 5 seconds, close the door and wait  

 

3 minutes for the dishwasher to go into sleep mode. In the OFF mode, the control display, control sounds,  

 

(on some models)  and interior lights will not respond to the door opening/closing. This mode can be used when observing certain  

 

 

 

religious holidays such as the Sabbath. To activate the control and interior lights, press any pad.

5