Amana AFI2539ERM 使用和维护

■

Your refrigerator has two adjustable, front leveling screws – 
one on each side of the refrigerator base. If your refrigerator 
seems unsteady or you want the door to close easier, use the 
instructions below.

■

Before moving the refrigerator, raise the leveling screws so the 
front rollers are touching the floor. 

1. Remove the two screws fastening the base grille to the 

cabinet, and set the screws aside. Grasp the grille and pull it 
toward you.

2. Raise or lower the cabinet. 

Using a 

¹⁄₄" hex driver, turn the leveling screw on each side to 

raise or lower that side of the refrigerator.

NOTE: Having someone push against the top of the 
refrigerator takes some weight off the leveling screws. This 
makes it easier to turn the screws. It may take several turns of 
the leveling screw to adjust the tilt of the refrigerator.

■

To raise, turn the leveling screw clockwise.

■

To lower, turn the leveling screw counterclockwise. 

3. Open the door again to make sure that it closes as easily as 

you like. If not, tilt the refrigerator slightly more to the rear by 
turning both leveling screws clockwise. It may take several 
more turns, and you should turn both screws the same 
amount.

4. Replace the base grille.

There are two refrigerator compartment doors. The doors can be 
opened and closed either separately or together.

There is a vertically-hinged seal on the left refrigerator door.

■

When the left-hand refrigerator door is opened, the hinged 
seal automatically folds inward so that it is out of the way.

■

When both doors are closed, the hinged seal automatically 
forms a seal between the two doors. 

The refrigerator and freezer controls are located on the dispenser 
panel.

IMPORTANT: The display screen on the dispenser control panel 
will turn off automatically and enter “sleep” mode when the 
control buttons and dispenser levers have not been used for 
2 minutes or more. While in “sleep” mode, the first press of a 
control button will only reactivate the display screen, without 
changing any settings. After reactivation, changes to any settings 
can then be made. If no changes are made within 2 minutes, the 
display will re-enter “sleep” mode. 

■

Touch any control button on the dispenser panel to activate 
the display screen. The home screen will appear as shown. 

A

B

A