White Westinghouse WWFC16M4RC 业主指南

13

•  Appliance operates at 

higher pressures during 

the start of the ON cycle.

•  This is normal. Sound will level off or dis-

appear as appliance continues to run.

•  Metal parts undergo ex-

pansion and contraction, as 

in hot water pipes.

•  This is normal. Sound will level off or dis-

appear as the appliance continues to run.

•  Refrigerant (used to cool 

the appliance) is circulating 

throughout the system.

•  This is normal.

•  Appliance is not level. It 

rocks on the floor when it 

is moved slightly.

•  Floor is uneven or weak. 

Appliance rocks on floor 

when it is moved slightly.

•  Appliance is touching  

the wall.

•  Level the unit. Refer to ”Leveling” in the 

INSTALLATION Section.  

•  Ensure floor can adequately support the ap-

pliance. Level the appliance by putting wood 

or metal shims under part of the appliance.

•  Re-level or move the appliance slightly. Refer 

to “Leveling” in the INSTALLATION Section.

•  Look on the control panel 

to determine which indica-

tor light is on (High Temp, 

Power Fail, or Door Ajar)

•  Press the “set” button to acknowledge the 

alarm or close the door if the door ajar 

indicator is shown.

•  Weather is hot and humid. 

•  Door may not be  

seating properly.

•  Door is opened too often 

or too long.

•  The rate of frost buildup and internal 

sweating increases. This is normal.

•  See “DOOR PROBLEMS”. 

•  Open door less often.

•  Door may not be seating 

properly, causing cold air 

from inside to meet warm 

air from outside.

•  See “DOOR PROBLEMS”.

•  Interior needs to be cleaned. 

•  Foods with strong odors 

are in the appliance.

•  Clean interior with sponge, warm water, 

and baking soda.

•  Cover the food tightly.

•  Appliance is not level. It  

rocks on the floor when it 

is moved slightly.

•  Floor is uneven or weak. 

Appliance rocks on floor 

when it is moved slightly.

•  This condition can force the cabinet out 

of square and misalign the door. Refer to 

“Leveling” in the INSTALLATION Section.

•  Level the floor by using wood or metal 

shims under the appliance or brace floor 

supporting the appliance.

•  LED may be burned out.
•  No electric current is 

reaching the appliance.

•  The door has been left open 

for more than 5 minutes.

•  Contact a qualified service dealer.
•  See “Appliance does not run” in  

“APPLIANCE OPERATION”.

•  Close the door.