Heartland HCFDR23BLK 业主指南

7

You will need the following tools:

Components 

provided:

Top hinge 

cover

rear screw

Top hinge cover

front screw

Lower

hinge

screw

Top

hinge

screw

Phillips™ Head

or #2 square 

drive head

(or)

(or)

(or)

(or)

And

Socket wrench set

Adjustable

wrench

3/8" Fixed

wrench

1/4" Nut

driver

This Use & Care Guide provides general installation and 

operating instructions for your model. We recommend 

using a service or kitchen contracting professional to install 

your refrigerator. Use the refrigerator only as instructed in 

this Use & Care Guide. 

•  Choose a place that is near a grounded, non-GFCI, 

electrical outlet. Do Not use an extension cord or an 

adapter plug.

•  If possible, place the refrigerator out of direct sunlight 

and away from the range, dishwasher, or other heat 

sources.

•  The refrigerator must be installed on a floor that is level 

and strong enough to support a fully loaded refrigerator.

•  Consider water supply availability for models equipped 

with an automatic ice maker.

DO NOT install the refrigerator where the temperature will 

drop below 55°F (13°C) or rise above 110°F (43°C). The 

compressor will not be able to maintain proper tempera-

tures inside the refrigerator.

DO NOT block the toe grille on the lower front of your re-

frigerator. Sufficient air circulation is essential for the proper 

operation of your refrigerator.

•  Allow the following clearances for ease of installation, 

proper air circulation, and plumbing and electrical con-

nections:

 

Sides & Top   ⅜ inch (9.5 mm)

 

Back    

1 inch (25.4 mm)

If your refrigerator is placed with the door hinge against a 

wall, you may have to allow additional space so the door 

can be opened wider.

The refrigerator doors are designed to shut by themselves 

within a 20 degree opening.

Your refrigerator should be positioned to allow easy access 

to a counter when removing food. For best use of refrigera-

tor drawers and freezer baskets, the refrigerator should be 

in a position where both can be fully opened.

•  All four corners of the cabinet must rest firmly on the 

floor.

•  The cabinet should be level at the front and rear.

•  The sides should tilt ¼ inch (6 mm) from front to back 

(to ensure that doors close and seal properly).

•  Doors should align with each other and be level.

Figure 10