GE PP7036SJSS 规格说明表单

Specification Created 1/15

Listed by 

Underwriters 

Laboratories

To insure accuracy, it is best to make a

template when cutting the opening in the counter

Electrical junction box 16" MIN.

below countertop

Cooktop

36-1/8"

20-1/2"

18-7/8"

33-3/4"

19-1/8" to

19-1/4"

33-7/8"

to 34"

PP9036SJ, PP7036SJ, JP5036SJ

2-1/2" MIN.

Required

1-3/4" MIN.

to rear wall

13" MAX. depth of unprotected

overhead cabinets (when no

hood or microwave is installed)

15" MIN. height from countertop

to nearest cabinet (including

light rails) on both sides of

cooktop

3-1/4" at front of unit and

6" at conduit location

30" MIN. from countertop to

unprotected cabinet (when

no hood or microwave is

installed)

2" MIN. clearance

to side wall from cut-out

on both sides of cooktop

See label next

to nameplate for

MIN. clearance

to wall

Important: Requires a 5" free area between 

the bottom of the cooktop to any combustible 

material, i.e., shelving. Free area not required 

when installing wall oven underneath cooktop. 
Refer to installation instructions. Requires 

a 15" minimum from cooktop to adjacent 
overhead cabinets. Units are furnished with a 

48" flexible armored cable. 
note: 36" Ribbon cooktops are approved for 

use over select GE 30" Single Wall Ovens and 
Warming Drawers. Refer to cooktop and wall 
oven/warming drawer installation instructions 

packed with product for current dimensional 
data. If installed with a GE Telescopic 
Downdraft System, consult both the cooktop 

and downdraft installation instructions packed 
with product before installing. Cooktop gas/
electric supply may need to be re-routed to 
install downdraft. The countertop cutout 
requires 23-1/2" minimum flat countertop 

surface and 25" minimum total countertop 

depth. In addition, other clearances to front 
edge of the countertop must be considered.   

current dimensional data. 

DImensIons anD InstallatIon InformatIon (In Inches)

pp7036sJ 

 

9.6

8.3

40 Amps

†

40 Amps

†

†

note: Check local codes 

for required breaker size

approxImate cookIng DImensIons