GE PHP9030DJBB 规格说明表单

Specification Created 1/15

Listed by 

Underwriters 

Laboratories

To insure accuracy, it is best to make a

template when cutting the opening in the counter

Electrical junction box 16" MIN.

below countertop

Cooktop

29-3/4"

21-3/8"

19-1/4"

28"

19-5/8"

to 19-3/4"

2-1/2" MIN.

Required

28-1/2" to

28-5/8"

1-3/4" MIN.

to rear wall

PHP9030DJ

4-5/8" at baffle near center of

unit (except when installed

above an approved wall oven)

and

3-1/4" at rear of air intake

13" MAX. depth of unprotected

overhead cabinets (when no

hood or microwave is installed)

30" MIN. from countertop to

unprotected cabinet (when

no hood or microwave is

installed)

2" MIN. clearance

to side wall from cut-out

on both sides of cooktop

15" MIN. height from countertop

to nearest cabinet (including

light rails) on both sides of

cooktop

Important: Requires a 5" free area between 

the bottom of the cooktop to any combustible 
material, i.e., shelving. Free area not required when 

installing wall oven underneath cooktop. Refer to 

installation instructions. Requires a 15" minimum 
from cooktop to adjacent overhead cabinets. Units 

are furnished with a 48" flexible armored cable. 
note: 30" induction cooktops are approved for 

use over select GE 27" and GE 30" Single Wall 

Ovens and Warming Drawers. Refer to cooktop and 

wall oven/warming drawer installation instructions 
packed with product for current dimensional 
data. If installed with a GE Telescopic Downdraft 

System, consult both the cooktop and downdraft 
installation instructions packed with product 
before installing. Cooktop gas/electric supply 
may need to be re-routed to install downdraft. 
The countertop cutout requires 23-1/2” minimum 

flat countertop surface and 25” minimum total 
countertop depth. In addition, other clearances  

to front edge of the countertop must be considered. 
Before installing, consult installation instructions 

packed with product for  current dimensional data. 
Cutout fIller trIm kIt: A filler trim kit 

is available for use if your countertop cutout is 

larger than the dimension shown, up to 29-13/16" x 
20-7/16". Order JXTR32B for black or JXTR32W 

for white, to reduce the cutout opening for 
installation of this cooktop. These kits may be 

ordered from your GE Dealer. 

DImensIons anD InstallatIon InformatIon (In InChes)

php9030DJ 

240V 7.3
208V 6.4

240V 30.8 Amps

†

208V 30.8 Amps

†

†note: Check local codes 

for required breaker size

approxImate CookIng DImensIons