Monogram ZIPX360NHSS 安装指导

16

• Locate and bring tubing to the front of the cabinet.

• Turn the water on to flush debris from line. Run about 

a quart of water through tubing into a bucket, then 

shut off water.

• Slip a 1/4” nut  and ferrule (provided) over both ends 

of the copper tubing. Insert tube into the union fitting 

on the unit and tighten nut to union.

• Turn on the water to check for leaks.

• Insert the molded end of the tubing into the  

refrigerator connection. Tighten the compression nut 

until it is just hand tight.

• Tighten one additional turn with a wrench. 

Overtightening can cause leaks!

• Turn on the water to check for leaks.

Note: Make sure excess tubing length does not  

interfere with drawer closing or toekick installation.

• Check to be sure the power cord is plugged into the 

receptacle.

• Check to make sure power to refrigerator is on by 

opening refrigerator door to see if interior lights are 

on.

• The temperature controls are preset at 37°F  

for the fresh food section and 0°F for the freezer.

• Allow 24 hours to stabilize before making 

adjustments.

•  Flip the switch to I (ON). The icemaker will begin 

operation automatically.

•  Be sure nothing interferes with the sweep of  

the feeler arm. 

• Discard the first full bucket of ice cubes.

• To turn the icemaker off, set the switch to O (OFF).

ON

OFF

729Dia26

Refrigerator

Water Supply

House

Water Supply

Master 

Light Switch

Electrical 

Outlet

Raise 

Grille 

Panel