Amana ART308FFDB 业主指南

2. Open both doors again to make sure they close as easily as 

you like. If not, tilt the refrigerator slightly more to the rear by 
turning both leveling legs to the left; it may take several more 
turns.
NOTE: To keep the refrigerator level, you should turn both 
leveling legs the same amount.

3. Using a level, be sure that the refrigerator is still level side to 

side. Readjust if necessary.

If the space between your doors looks uneven, you can adjust it 
using the following instructions:
1. Depending on your model, remove the top hinge cover. 
2. Loosen the top hinge screws using a 

⁵⁄₁₆" socket or wrench.

3. Have someone hold the door in place or put a spacer between 

the doors while you tighten the top hinge screws.

4. Replace the top hinge cover, if removed in Step 1. 

Your refrigerator has two controls that affect the temperature. The 
Temperature control is located at the top front of the refrigerator 
compartment and the Airflow control is located on the back wall 
of the freezer compartment.
IMPORTANT: 

■

The recommended setting should be correct for normal 
household refrigerator use. The controls are set correctly 
when milk or juice is as cold as you like and when ice cream is 
firm.

■

Wait 24 hours for your refrigerator to cool completely before 
adding food. If you add food before the refrigerator has cooled 
completely, your food may spoil.

NOTE: Adjusting the refrigerator and freezer temperature 
controls to a colder than recommended setting will not cool 
the compartments any faster.

■

If the temperature is too warm or too cold in the refrigerator or 
freezer, first check the air vents to be sure they are not 
blocked before adjusting the controls.

For your convenience, the temperature control is preset at the 
factory. When you first install your refrigerator, make sure the 
control is still preset as shown.

■

To turn Cooling Off, press and hold the Temperature Setting 
button for 4 seconds, until all lights turn ON for 1 second. To 
turn cooling back on, press and hold the Temperature Setting 
button again for 4 seconds. 

NOTE: Neither compartment will cool when the control is set 
to OFF.   

If you need to adjust the temperature in either the refrigerator or 
freezer compartment, use the settings listed in the chart below as 
a guide.
NOTE: Except when starting the refrigerator, do not adjust the 
control more than one setting at a time. Wait 24 hours between 
adjustments for the temperature to stabilize. 

■

Press the Temperature Setting button to toggle among the 
three LED lights which indicate the temperature setting. 
Reading from left to right, the LED in the first position is the 
least cold. The LEDs indicate increasingly colder settings as 
you continue to the right. 

The Airflow control regulates the amount of air flowing between 
the freezer and the refrigerator compartments. 
When you plug in the refrigerator for the first time, turn the Airflow 
control to the Recommended setting. 

If you want to temporarily increase the cold airflow to a specific 
compartment, adjust the control.

■

Max - Increase airflow to the freezer

■

Min - Increase airflow to the refrigerator

IMPORTANT: Once the performance is achieved, return the 
Airflow control to the Recommended setting to keep the 
refrigerator operating at optimum efficiency. 

REFRIGERATOR too warm

TEMPERATURE Control one 
setting higher 

FREEZER too warm/too 
little ice

AIRFLOW or TEMPERATURE 
Control one setting higher

REFRIGERATOR too cold

TEMPERATURE Control one 
setting lower

FREEZER too cold

AIRFLOW or TEMPERATURE 
Control one setting lower

Heavy ice use

Max 

Hot room temperature

Max - To maintain ice making 
production rate

Large quantity of groceries

Min - To quickly chill food and 
beverages