Amana ART106TFD 手册

1. Unplug refrigerator or disconnect power.
2. Disconnect the tube clamp on the back of the product and 

insert the copper tubing through the clamp as shown.

3. Attach the copper tube to the valve inlet using a compression 

nut and sleeve as shown.

4. Tighten the compression nut. Do not overtighten. Reattach the 

tube clamp and tube to the back of the cabinet. 

5. Turn shutoff valve ON. Check for leaks. Tighten any 

connections (including connections at the valve) or nuts that 
leak.

6. The ice maker is equipped with a built-in water strainer. If your 

water conditions require a second water strainer, install it in 
the 

¹⁄₄" (6.35 mm) water line at either tube connection. Obtain 

a water strainer from your nearest appliance dealer.

1. Plug into a grounded 3 prong outlet. 
NOTE: Allow 24 hours to produce the first batch of ice. Discard 
the first three batches of ice produced. Allow 3 days to completely 
fill ice container.

■

Before you begin, turn the refrigerator control OFF. Unplug 
refrigerator or disconnect power. 

■

Remove food and adjustable door or utility bins from doors.

■

If you are only removing and replacing the doors, see the 
“Remove Doors and Hinges” and “Replace Doors and 
Hinges” sections.

■

All graphics referenced in the following instructions are 
included later in this section after “Final Steps.”

⁵⁄₁₆

1. Unplug refrigerator or disconnect power.
2. Close the refrigerator door and keep both doors closed until 

you are ready to lift them free from the cabinet.
NOTE: Provide additional support for the doors while the 
hinges are being moved. Do not depend on the door magnets 
to hold the doors in place while you are working.

3. Remove the parts for the top hinge as shown in Top Hinge 

graphic. Lift the freezer door free from the cabinet.

4. Remove the parts for the center hinge as shown in the Center 

Hinge graphic. Lift the refrigerator door free from the cabinet.

5. Remove the parts for the bottom hinge as shown in the 

Bottom Hinge graphic.

IMPORTANT: If you want to reverse your doors so that they open 
in the opposite direction, follow these steps. If you are not 
reversing the doors, see “Replace Doors and Hinges.”
Graphics follow these instructions. 

1. Remove 

⁵⁄₁₆" hex head hinge screws from handle side and 

move them to opposite side. See Graphic 1.

2. Remove cabinet hinge hole plugs from cabinet top and   

move them to opposite side hinge holes as shown. 
See Graphic 2.

A

B

C

■

⁵⁄₁₆" Hex head socket 

wrench

■

⁵⁄₁₆" Open-end wrench

■

#2 Phillips screwdriver

■

Flat 2" putty knife

■

Flat-blade screwdriver

Door Stop Screw

Door Hinge Hole Plug

Cabinet Hinge Hole Plug

Dome Cap

Dome Cap Washer