Dacor DHW361 安装指南

Dimensions

Tolerances: ±1/16” (±1.6 mm), -0 unless otherwise stated

* 18” 1/4 on model DHW482 with exhaust cowling
IMPORTANT: The minimum installed distance from the 

hood to the cooking surface must be no less than 30 

inches. The minimum specified distance may be higher 

for the particular range or cooktop in use. Check the 

manufacturers specifications for the cooktop or range.

Planning the Location

Observe all governing codes and ordinances during 

planning and installation. Contact your local building 

department for further information.

 

■ Carefully check the location where the hood is to be 

installed. The hood should be placed for convenient 

access. Make certain that electrical power can be 

provided in the selected location.

 

■ The hood model selected must be as wide as the 

cooktop surface or wider.

 

■ All contact surfaces between the hood and any cabi-

nets or walls must be solid and at right angles.

 

■ Install the range hood and cooking appliance(s) so 

that they can be removed if service is required.

 

■ Plan the installation so that all minimum dimensions 

are met or exceeded. Dimensions shown above pro-

vide minimum clearances, unless otherwise noted.

Performance Specifications

All Models

Blower

600 CFM* (for single blower units)

1200 CFM* (for dual blower units) 

Blower Speeds 4 with electronic speed control

Lights

12 Vac, 20 Watt halogen

Filters

Baffle type, dishwasher safe

Exhaust

8-inch

Finish

430 stainless steel

Total Connected 

Load

120 Vac, 60 Hz.  

(See table below for current draw)

Circuit

Requirement

120 Vac, 15 Amp. grounded,  

dedicated circuit, minimum

* At zero inches static pressure

Model Specific

DHW301

1

2

1

3.4 Amp.

DHW361

1

2

1

3.4 Amp.

DHW421

1

3

1

3.6 Amp.

DHW482

2

4

2

6.8 Amp.

Electrical Specifications

The electrical service to the range hood should be 

installed only by a licensed electrician.

It is the owner’s responsibility to ensure that the electrical 

connection of this appliance is performed by a qualified 

electrician. The electrical installation, including minimum 

supply wire size and grounding, must be in accordance 

with the National Electric code ANSI/NFPA* (or latest 

revision) and local codes and ordinances.
* A copy of this standard may be obtained from:
National Fire Protection Association  

1 Batterymarch Park 

Quincy, Massachusetts 02269-9101
Connect the hood to a junction box supplied by a 120 

Vac, 60 Hz. dedicated, grounded, 3-wire (hot, neutral, 

ground) circuit protected by a 15 Amp. circuit breaker or 

time delay fuse. Locate the junction box a minimum of 

17” (43.2 cm) above the bottom of the range hood (for 

example, attached to a stud).

Installation Specifications 

Chimney 

24”

(61.0 cm)

Min. 30 1/4” (76.8 cm) Max. 42” (106.7 cm)

30” - 36” - 42” - 48”

15”

(38.1 cm)

11 3/4”

(29.8 cm)

5 3/4”

(14.6 cm)

12 1/2” (31.8 cm)

16 1/4” * (41.3 cm)