Faber INSM24GR 规格说明表单
5” round
duct
cabinet
ceiling
hood
cabinet
ceiling
soffit
5” round
duct
hood
Side View
Bottom View
Dimensional Diagrams
Rev.07/11
WARNING!
Product specifications are subject to change without notification. Consult the installation instructions before
you begin installing this rangehood.
Make your ductrun as straight and short as pos-
sible. The ductrun should not exceed 25 equiva-
lent feet if ducted with the required minimum of
5” round duct. Count 45º angles as 3 feet, 90º
elbows as 5 feet, and 90º flat elbows as 12 feet.
sible. The ductrun should not exceed 25 equiva-
lent feet if ducted with the required minimum of
5” round duct. Count 45º angles as 3 feet, 90º
elbows as 5 feet, and 90º flat elbows as 12 feet.
For best results, use no more than three 90°
elbows. Make sure that there is a minimum of
24” of straight duct between elbows if more
than one is used. Do not install two elbows
together. If you must elbow right away, do it as
far away from the hood’s exhaust opening as
possible.
elbows. Make sure that there is a minimum of
24” of straight duct between elbows if more
than one is used. Do not install two elbows
together. If you must elbow right away, do it as
far away from the hood’s exhaust opening as
possible.
Recirculating Installations
Some ductwork must be
installed to exhaust the
rangehood back into the
kitchen, either at the top
of the cabinet or at the
face of the soffit. This duct
work must not terminate
into a dead air space.
installed to exhaust the
rangehood back into the
kitchen, either at the top
of the cabinet or at the
face of the soffit. This duct
work must not terminate
into a dead air space.
For installations where ductwork to the outside of your home is impossible or highly impractical
Charcoal Filters, which insert behind the grease filters, absorb smoke and odors.
Charcoal Filters, which insert behind the grease filters, absorb smoke and odors.
Front View
Liners
Standard Liner 36 Stainless (LINE36ST)
designed for 36” wide installations
designed for 36” wide installations
Standard Liner 30 Stainless (LINE30ST)
designed for 30” wide installations
designed for 30” wide installations
Create a perfectly-sealed, non-combustible perimeter around the Inca Smart. Designed for 30” and 36” wide installations. Depth adjustable from 16” - 17 7/8”.
Note: Standard Liners are pre-cut for installation of Inca Smart. For installations with the Inca HC
SS, remove the additional perforated section.
SS, remove the additional perforated section.
Pre-Planning Your Installation
-
Important: Consult the installation instructions before you begin installing this rangehood. The
recommended height to install this hood off the cooktop is a minimum of 24” and a maximum of 30” for maximum effectiveness. Also consult the cooktop
manufacturer’s recommendation.
manufacturer’s recommendation.
Cut Out