Elica EAL330BL 安装指导

下载
页码 12
10
Controls
Use the high suction speed in cases of concentrated kitchen 
vapours.  It is recommended that the cooker hood suction is 
switched  on  for  5  minutes  prior  to  cooking  and  to  leave  in 
operation  during  cooking  and  for  another  15  minutes
approximately after terminating cooking.  
Description of control panel 
Maintenance
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the
connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. 
Cleaning
Do not spray cleaners directly to the control while 
cleaning the Hood.The cooker hood should be cleaned 
regularly (at least with the same frequency with which you 
carry out maintenance of the fat filters) internally and 
externally.  Clean using the cloth dampened with neutral 
liquid detergent. Do not use abrasive products. 
DO NOT 
USE ALCOHOL!
WARNING: 
Failure to carry out the basic cleaning recommendations of 
the  cooker  hood  and  replacement  of  the  filters  may  cause 
fire risks.
Therefore, we recommend oserving these instructions. 
The manufacturer declines all responsibility for any damage 
to  the  motor  or  any  fire  damage  linked  to  inappropriate 
maintenance  or  failure  to  observe  the  above  safety 
recommendations. 
Grease Filter 
Traps cooking grease particles. 
This  must  be  cleaned  once  a  month  using  non  aggressive 
detergents, either by hand or in the dishwasher, which must 
be  set  to  a  low  temperature  and  a  short  cycle.    When 
washed  in  a  dishwasher,  the  grease  filter  may  discolour 
slightly, but this does not affect its filtering capacity. 
To remove the grease filter, pull the spring release handle. 
Replacing the light bulb 
CAUTION
Before  replacing  the  lamps,  switch  power  off  at  service 
panel  and  lock  service  panel  disconnecting  means  to
prevent power from being switched on accidentally. 
NOTE:  Turn  off  the  lights  and  fan.    Allow  the  lights  to  
cool  before  handling. If  new  lights  do  not  operate  be 
sure lights are inserted correctly before calling service. 
Replace Lights  
•  Remove  the  damaged  light  (twist    counter  clockwise) 
and  replace  with  a  new  120  Volt,  50  Watt  (maximum) 
50°  halogen  light  made  for  a  GU10  base, 
suitable  for 
use in open luminarie.
1. ON/OFF Light
2. ON/OFF general and speed1.
3. ON/OFF, speed 2 and speed 3.