Frigidaire FFEC3225MB 业主指南

9

The cooktop is equipped with one or two dual radiant 

surface element. Symbols around the knob are used to 

indicate which coil of the dual radiant element will heat. 

The small digits on the control knob indicate that only the 

inner coil will heat (Fig. 1). The large digits on the control 

knobs indicate that both inner and outer coils will heat 

(Fig. 2). You may switch from either coil setting at any 

time during cooking.

1.  Place correctly sized cookware on the dual surface 

element.

2.  Push in and turn the control knob as shown in Figure 1 

for smaller cookware or in Figure 2 for larger cookware.

3.  Turn the knob to adjust the setting if needed. Start 

most cooking operations on a higher setting and then 

turn to a lower setting to finish cooking. Each surface 

element provides a constant amount of heat at each 

setting. A glowing red surface heating area extending 

beyond the bottom edge of the cookware indicates the 

cookware is too small for the surface heating area.

4.  When cooking has completed, turn the surface 

Figure 1

Figure 2

Some models have an indicator light for each heating 

unit, other models have an indicator light for each pair of 

heating units, also some other models have an indicator 

light for all heating units.

The indicator light glows as soon as a heating unit is 

turned on. Check if the indicator light glows when the 

control knob of the individual heating unit is turned on. 

If the knob is set to a very low temperature setting, the 

indicator may glow and yet, the heating unit may not be 

heating at all. If this happens, turn the knob to a higher 

setting until the heating unit comes on.

When cooking is finished, a quick glance at the indicator 

lights in an easy check to be sure all the control knobs 

have been turned OFF.

(ceramic glass cooktop models only)
Some models have an indicator light located on the 

ceramic glass cooktop that glows as soon as the glass 

begins to warm up. When the heating unit is turned 

off, it will continue to glow as long as the glass remains 

warm enough to cause burns. Other models have a hot 

surface indicators per element arranged in a cluster. Their 

location is as shown in the illustration.

(Typical 30" cooktop shown)