Amana ASD2575BRS 业主指南

IMPORTANT: This refrigerator is designed for indoor household 
use only.
To ensure proper ventilation for your refrigerator, allow for 

¹⁄₂" 

(1.27 cm) of space on each side and at the top. Allow for 2" 
(5.08 cm) of space behind the refrigerator. If your refrigerator has 
an ice maker, allow extra space at the back for the water line 
connections. When installing your refrigerator next to a fixed wall, 
leave a 2" (5.08 cm) minimum space on each side (depending on 
your model) to allow the doors to swing open.   

NOTES: 

■

This refrigerator is intended for use in a location where the 
temperature ranges from a minimum of 55°F (13°C) to a 
maximum of 110°F (43°C). The preferred room temperature 
range for optimum performance, which reduces electricity 
usage and provides superior cooling, is between 60°F (15°C) 
and 90°F (32°C). It is recommended that you do not install the 
refrigerator near a heat source, such as an oven or radiator.

■

Normal minimum cabinet cut-out width required for product 
installation is 36" (91.44 cm). However, if the product is placed 
against an extended wall and the ability to remove the crisper 
pans is desired, an additional 18" (45.72 cm) of cabinet width 
is required, so a total cabinet opening width of 54" 
(137.16 cm) is recommended.

Before you move your refrigerator into its final location, it is 
important to make sure you have the proper electrical connection.

A 115 volt, 60 Hz, AC only, 15- or 20-amp fused, grounded 
electrical supply is required. It is recommended that a separate 
circuit serving only your refrigerator be provided. Use an outlet 
that cannot be turned off by a switch. Do not use an 
extension cord.
NOTE: Before performing any type of installation or cleaning, or 
removing a light bulb, turn cooling off or turn the control 
(Thermostat, Refrigerator or Freezer Control depending on the 
model) to OFF, and then disconnect the refrigerator from the 
electrical source. When you are finished, reconnect the 
refrigerator to the electrical source and turn cooling on or reset the 
control (Thermostat, Refrigerator or Freezer Control depending on 
the model) to the desired setting. See “Using the Controls” in the 
User Instructions, User Guide, or Use & Care Guide.

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.
TOOLS NEEDED:  

NOTE: Your refrigerator dealer has a kit available with a 

¹⁄₄" 

(6.35 mm) saddle-type shutoff valve, a union, and copper tubing. 
Before purchasing, make sure a saddle-type valve complies with 
your local plumbing codes. Do not use a piercing-type or 

³⁄₁₆" 

(4.76 mm) saddle valve which reduces water flow and clogs more 
easily.
IMPORTANT:

■

All installations must meet local plumbing code requirements.

■

Use copper tubing and check for leaks. Install copper tubing 
only in areas where the household temperatures will remain 
above freezing.

■

Flat-blade screwdriver

■

⁷⁄₁₆" and ¹⁄₂" Open-end or two 

adjustable wrenches

■

¹⁄₄" Nut driver

■

¹⁄₄" Drill bit

■

Cordless drill