Amana ASD2275BRS 业主指南

1. Plug into a grounded 3 prong outlet.
2. Flush the water system. See “Water and Ice Dispensers” in the 

User Instructions or User Guide.

NOTE: Allow 24 hours to produce the first batch of ice. Allow 
72 hours to completely fill ice container.

For your convenience, your refrigerator controls are preset at the 
factory. When you first install your refrigerator, make sure that the 
controls are still preset. The Refrigerator Control and the Freezer 
Control should both be set to the “mid-settings.” 

■

Your product will not cool when the REFRIGERATOR Control 
is set to OFF.

■

The Refrigerator Control adjusts the refrigerator compartment 
temperature. The Freezer Control adjusts the freezer 
compartment temperature. Settings to the left of the 
mid-setting make the temperature less cold. Settings to the 
right of the mid-setting make the temperature colder.

■

Wait 24 hours before you put food into the refrigerator. If you 
add food before the refrigerator has cooled completely, your 
food may spoil.

NOTE: Adjusting the Refrigerator and Freezer Controls to a higher 
(colder) than recommended setting will not cool the 
compartments any faster.

Give the refrigerator time to cool down completely before adding 
food. It is best to wait 24 hours before you put food into the 
refrigerator. The settings indicated in the previous section should 
be correct for normal household refrigerator usage. The controls 
are set correctly when milk or juice is as cold as you like and when 
ice cream is firm. 

■

Turn the control right (clockwise) to make the compartment 
colder. 

■

Turn the control left (counterclockwise) to make it less cold. 

■

To turn the cooling system off, turn the Refrigerator Control 
counterclockwise until it reaches the OFF position.

If you need to adjust temperatures in the refrigerator or freezer, 
use the settings listed in the chart below as a guide. Wait at least 
24 hours between adjustments.

You can control the amount of humidity in the moisture-sealed 
crisper. Adjust the control to any setting between LOW and HIGH.
LOW (open) for best storage of fruits and vegetables with skins. 
HIGH (closed) for best storage of fresh, leafy vegetables. 

■

The dispensing system will not operate when either door 
(refrigerator or freezer) is open.

■

Allow 24 hours for the refrigerator to cool down and chill 
water.

■

Allow 24 hours to produce the first batch of ice. Discard the 
first three batches of ice produced. Wait 72 hours for full ice 
production.

Air in the water dispensing system can cause the water dispenser 
to drip. After connecting the refrigerator to a water source or 
replacing the water filter, flush the water system. Flushing the 
water dispensing system forces air from the water line and filter, 
and prepares the water filter for use.
NOTE: As air is cleared from the system, water may spurt out of 
the dispenser.

REFRIGERATOR 
too warm

REFRIGERATOR Control one 
setting higher 

FREEZER too warm/
too little ice

FREEZER Control one setting 
higher

REFRIGERATOR 
too cold

REFRIGERATOR Control one 
setting lower

FREEZER too cold

FREEZER Control one setting lower