Dacor DTF364SIWS 设计指南

All specifications subject to change without notice.

Phone: (800) 793-0093

www.dacor.com

Document # PG11-015

Revised 04/04/14   Page 1/1

The refrigerator can be recessed in an opening between cabinets or 

installed at the end of a cabinet run using a side panel to enclose it.
◊

Install the refrigerator at least 12” (30 cm) away from heat sources 

such as ranges, cooktops, ovens and heaters. Do not choose a 

location that exposes the appliance to direct sunlight or humidity.

◊

Appropriate air ventilation must be provided. Leave at least 2” (5 cm) 

distance above and to the sides of the appliance.

◊

Do not locate the refrigerator on tops of rugs or carpets.

◊

Place the appliance on an even floor surface for stability.

◊

Do not install the refrigerator in places where the temperature falls 

below 50°F (10ºC).

◊

If two refrigerators are to be installed side by side, there should be at 

least 2” (5 cm) minimum distance between them.

•  Observe all governing codes and ordinances during planning 

and installation. Contact your local building department for 

further information. 

•  This appliance must be installed in accordance with the 

accompanying installation instructions.

◊

A grounded three prong, non-GFCI electrical outlet must be provided 

and should be in a location that allows the refrigerator to be 

connected without an extension cord. 

◊

A 115 Volt, 60 Hz. AC only 15 or 20 Amp. fused, grounded electrical 

supply is required. It is recommended that a separate circuit serving 

only your refrigerator be provided. Use an outlet that cannot be turned 

off by a switch. It must be protected by an appropriate sized fuse or 

circuit breaker. 

◊

The power plug must be within easy reach after installation without 

using and extension cord. Do not use an adapter plug.

◊

A cold water supply with water pressure of between 14.5 psi and 115 

psi (100 and 800 kPa) is required to operate the water dispenser and 

ice maker. If you have questions about your water pressure, call a 

licensed, qualified plumber.

◊

Install a shut off valve between the refrigerator and water supply. Use 

1/4” copper tubing with a compression nut and compression sleeve 

and check for leaks. Install copper tubing only in areas where the 

household temperatures will remain above freezing.

◊

Do not use a piecing type or 3/16” (5 mm) saddle valve which will 

reduce water flow and clog more easily.

◊

The plumbing for the water line can come through the floor flush to 

or from the back wall. Install the water valve in a location that allows 

it to be turned off without moving the refrigerator out in the event the 

refrigerator or water line requires service.

IMPORTANT: The pressure of the water supply coming out of a reverse 

osmosis system going to the water inlet valve of the refrigerator needs to 

be between 14.5 psi and 115 psi (100 and 800 kPa).

35 3/4”

(90.8 cm)

33 7/8”

(86.1 cm)

72 3/4”

(185.0 cm)

36 1/4”

(92.1 cm)

A

B

C

A = 13/16" (2.1 cm)   

B refrigerator = 32 1/8" (81.6 cm) 

B freezer door = 17 1/4" (43.8 cm) 

C = 2 3/8" (6.0 cm)